Abstract:Changes in mechanical properties of rocks at high temperatures are significant to various scientific and engineering problems, such as efficient exploration in enhanced geothermal systems (EGS) and rock mass stability in radioactive waste disposal. However, a comprehensive understanding of changes in rock mechanical behaviors at high temperatures and corresponding mechanisms, especially granites, remains unclear, which calls for the examination of micromechanical properties of the constituent minerals. This work investigates four representative minerals in granites, including quartz, plagioclase, amphibole, and biotite. The micromechanical properties of these minerals in the heating–cooling cycle were characterized in real time by using the nanoindentation technique. The morphology of samples was observed not only under real-time cyclic heating–cooling conditions, but also after thermal treatment. Subsequently, changes in structure of the minerals at elevated temperatures based on X-ray diffraction (XRD) were studied. Thermogravimetric analysis coupled with Fourier's transform infrared spectroscopy (TG-FTIR) was performed to examine physio-chemical alterations of minerals at high temperatures. The experimental results revealed that the reduced modulus and hardness of quartz decreased during heating and subsequently increased during cooling. During the heating–cooling cycle, the hardness of plagioclase varied similarly to that of quartz, but its reduced modulus increased up to approximately followed by a decrease during heating. Unlike the net decrease of modulus of quartz after exposure to the heating–cooling cycle, feldspar showed a net increase of modulus. The micromechanical properties of biotite were found to rise significantly during heating, followed by a decrease during cooling. XRD results suggested the alteration of mineral structure, including spacing of lattice planes, crystallinity, and phase transitions, which controlled the above changes in mechanical behaviors of quartz, amphibole, and plagioclase. However, the aperture of open cracks along the cleavage in biotite determined its micromechanical properties during heating and cooling. Thermally-induced microcracks were observed during heating; whereas, closure of pre-existing cracks and initiation of microcracks were found during cooling. The real-time measured micromechanical properties of minerals could relate to the macromechanical behaviors of rocks under heating–cooling conditions based on thermally-induced microcracks.

The Effect of Weathering on the Mineral Grains and Macroscale Young's Modulus of Granites

Study on the mechanical properties and microscopic evolution mechanisms of weathered granite soil

The Effect of Grain Size Heterogeneity on Mechanical and Microcracking Behavior of Pre-heated Lac Du Bonnet Granite Using a Grain-Based Model

An advanced grain-based model to characterize mechanical behaviors of crystalline rocks with different weathering degrees

Modeling damage evolution in granite under temperature using a thermo-mechanical grain-based FDEM model

Real-Time Measurement of Mechanical Behavior of Granite During Heating–Cooling Cycle: A Mineralogical Perspective

Experimental and meso-scale numerical modeling of splitting tensile behavior of weathered granites from South China

Investigation into the effects of grain size on strength and failure behaviors of granites using a breakable polygonal grain–based model

Research on the Impact Mechanical Properties of Real-Time High-Temperature Granite and a Coupled Thermal-Mechanical Constitutive Model

Laboratory Investigation on Physical and Mechanical Behaviors of Granite after Heating and Different Cooling Rates

Numerical Investigation of Hydro-Mechanical (HM) Effect on Meso-Failure Properties of Granite Using Improved HM Grain-Based Model

A grain texture model to investigate effects of grain shape and orientation on macro-mechanical behavior of crystalline rock

Analysis of physical and mechanical behaviors and microscopic mineral characteristics of thermally damaged granite

The Influence of Mechanical Heterogeneity of Grain Boundary on Mechanical and Microcracking Behavior of Granite Under Mode I Loading Using a Grain-Based Model

Modeling Damage Evolution in Heterogeneous Granite Using Digital Image-Based Grain-Based Model

Effects of inhomogeneity on mechanical properties of granites in Songliao Basin using the grain-based model

Modelling Thermo-hydro-mechanical (THM) Effect on the Hydro-mechanical Properties of Granite in Disposal System Using an Improved Meso-structure-Based DEM Model

Thermal Influence on Mechanical Properties of Granite: A Microcracking Perspective

Grain-based Coupled Thermo-Mechanical Modeling for Stressed Heterogeneous Granite under Thermal Shock

Investigating Mechanical Characteristics of Rocks Under Freeze–Thaw Cycles Using Grain-Based Model

Numerical investigation of the effects of the micro-parameters of the transgranular contact on the mechanical response of granite