Abstract:Signal to noise ratios (SNR) in magnetic resonance microscopy images are limited by acquisition times and the decreasing number of spins in smaller voxels. Significant SNR gains from cooling of the RF receiver are only realized when the Johnson noise generated within the RF hardware is large compared to the electromagnetic noise produced by the sample. Cryogenic cooling of imaging probes is common in high field systems but proves difficult to insulate the sample from extreme temperatures. We designed a chamber to cool only the tune and match circuitry to show it is possible to achieve much of the available SNR gain available for cooled coils. We designed a microcoil circuit to resonate at 650 MHz for imaging on a 15.2 T scanner. Surface loops and solenoids of varying diameters were tested to determine the largest diameter coil that demonstrated significant SNR gains from cooling. A liquid N2 cryochamber was designed to cool the circuitry while leaving the RF coil in ambient air. As the cryochamber was filled with liquid N2, Q-factors were measured on the bench while monitoring the coil's surface temperature. Improvements of SNR on images of solutions were demonstrated via cooling the tune and match circuit in the magnet bore. At 650 MHz, loops and solenoids < 3 mm in diameter showed significant improvements in quality factor on the bench. The resistance of the variable capacitors and the coaxial cable were measured to be 45% and 32% of room temperature values near the Larmor frequency. Images obtained with a 2 turn, 3 mm diameter loop with the matching circuit at room temperature and then cooled with liquid nitrogen demonstrated SNR improvements of a factor of 2. By cooling the tune and match circuit and leaving the surface loop in ambient air, SNR was improved by a factor of 2. The results are significant because it allows for more space to insulate the sample from extreme temperatures.

Reducing current noise in cryogenic experiments by vacuum-insulated cables

EXPERIMENTAL RESEARCH OF THERMAL-COUPLED VERSION HIGH FREQUENCY TWO-STAGE PULSE TUBE COOLER

Vibration-induced electrical noise in a cryogen-free dilution refrigerator: characterization, mitigation, and impact on qubit coherence

Cryogenic-temperature Thermoacoustically Driven Pulse Tube Refrigerator

Thermoacoustically Driven Pulse Tube Refrigeration below 80K by Introducing an Acoustic Pressure Amplifier

Investigation Of Helium And Nitrogen Mixtures In A Pulse Tube Refrigerator

120 Hz Pulse Tube Cryocooler For Fast Cooldown To 50 K

Modeling and Experiments on Fast Cooldown of A 120 Hz Pulse Tube Cryocooler

Optimization of an 8K Level High Frequency Pulse Tube Cryocooler

Vibrations on pulse tube based Dry Dilution Refrigerators for low noise measurements

Pulse tube cryocooler with self-cancellation of cold stage vibration

Cryogenic broadband vibration measurement on a cryogen-free dilution refrigerator

Ultra-stable dry cryostat for variable temperature break junction

Vibration decoupling system for massive bolometers in dry cryostats

Vibration Property of a Cryogenic Optical Resonator within a Pulse-Tube Cryostat

Damping of intrinsic temperature oscillations in a 4 K pulse tube cooler by means of rare earth plates

Cryogenic receive coil and low noise preamplifier for MRI at 0.01T

A Cryogenic Tune and Match Circuit for Magnetic Resonance Microscopy at 15.2T

Dynamic acoustic optimization of pulse tube refrigerators for rapid cooldown

A 10 mK hermetic cell for eliminating parasitic heating in cryogen-free dilution refrigerators

An active noise cancellation technique for the CUORE Pulse Tube Cryocoolers