Abstract:The article is the continuation of a cycle of works published in a Special Issue of MDPI entitled "Innovative Technologies and Materials for the Production of Mechanical, Thermal and Corrosion Wear-Resistant Surface Layers and Coatings" related to tests concerning the microstructure and mechanical properties of innovative surface layers made using the Powder Plasma Transferred Arc Welding (PPTAW) method and intended for work surfaces of drilling tools and machinery applied in the extraction industry. A layer subjected to tests was a metal matrix composite, made using powder based on a nickel alloy containing spherical fused tungsten carbide (SFTC) particles, which are fused tungsten carbide (FTC) particles and spherical particles of tungsten-coated synthetic metal-diamond composite (PD-W). The layer was deposited on the substrate of low-alloy structural steel grade AISI 4715. The results showed that the chemical composition of the metallic powder as well as the content of the hard phase constituting the matrix enabled the making of a powder filler material characterised by very good weldability and appropriate melting. It was also found that the structure of the Ni-WC-PD-W layer was complex and that proper claddings (characterised by the uniform distribution of tungsten carbide (WC)) were formed in relation to specific cladding process parameters. In addition, the structure of the composite layer revealed the partial thermal and structural decomposition of tungsten carbide, while the particles of the synthetic metal-diamond composite remained coherent. The deposited surface layer was characterised by favourable resistance to moderate dynamic impact loads with a potential energy of 200 J, yet at the same time, by over 12 times lower metal-mineral abrasive wear resistance than the previously tested surface layer made of cobalt-based composite powder, the matrix of which contained the hard phase composed of TiC particles and synthetic metal-diamond composite. The lower abrasive wear resistance could result from a different mechanism responsible for the hardening of the spherical particles of the hard phase susceptible to separation from the metal matrix, as well as from a different mechanism of tribological wear.

Fabrication and use of Cu-Cr-diamond composites for the application in deep feed grinding of tungsten carbide

Influence of the powder metallurgy route on the mechanical properties of Cu–Cr–diamond composites

Fabrication and application of nano–microcrystalline composite diamond films on the interior hole surfaces of Co cemented tungsten carbide substrates

High thermal conductivity Cu-3Cr/Diamond composites fabricated by powder metallurgy

Grinding performance of electroplated diamond tools strengthened with Cr-C deposit using D-150 diamond particles

Cu-induced enhancement of interfacial bonding for brazed diamond grits with NiCr filler alloys

Fabrication and Cutting Performance of Ultrafine Grain Composite Diamond Coated Drills

Fabrication of Diamond/w–cu Functionally Graded Material by Microwave Sintering

Fabrication of copper/diamond functionally graded materials for grinding wheels by centrifugal sintered-casting

Machining performance of micro-pit and micro-groove composite textured tools in tungsten alloy turning

On the tribology and grinding performance of graphene-modified porous composite-bonded CBN wheel

Tribological studies on ultra-fine diamond composite coatings deposited on tungsten carbide

Fabrication and Evaluation of Monolayer Diamond Grinding Tools by Hot Filament Chemical Vapor Deposition Method

Fabrication and application of CVD diamond coated cutting tools

Mechanical Alloying of Copper- or Iron-Based Metallic Binders for Diamond Tools

The Microstructure and Wear Properties of Diamond Composite Coatings on TC4 Made by Induction Brazing

High-strength and wear-resistant Co-Cr-Mo/diamond composites fabricated by selective laser melting

Improvement in Hardness and Wear Behaviour of Iron-Based Mn–Cu–Sn Matrix for Sintered Diamond Tools by Dispersion Strengthening

Nanoengineered Polycrystalline Diamond Composites with Advanced Wear Resistance and Thermal Stability

Manipulating in-situ discrete carbide interlayer to achieve high thermal conductivity in Cu-B/diamond composite