Abstract:A PET block detector module using an array of sub-millimeter lutetium oxyorthosilicate (LSO) crystals read out by an array of surface-mount, semiconductor photosensors has been developed. The detector consists of a LSO array, a custom acrylic light guide, a 3 x 3 multi-pixel photon counter (MPPC) array (S10362-11-050P, Hamamatsu Photonics, Japan) and a readout board with a charge division resistor network. The LSO array consists of 100 crystals, each measuring 0.8 x 0.8 x 3 mm(3) and arranged in 0.86 mm pitches. A Monte Carlo simulation was used to aid the design and fabrication of a custom light guide to control distribution of scintillation light over the surface of the MPPC array. The output signals of the nine MPPC are multiplexed by a charge division resistor network to generate four position-encoded analog outputs. Flood image, energy resolution and timing resolution measurements were performed using standard NIM electronics. The linearity of the detector response was investigated using gamma-ray sources of different energies. The 10 x 10 array of 0.8 mm LSO crystals was clearly resolved in the flood image. The average energy resolution and standard deviation were 20.0% full-width at half-maximum (FWHM) and +/-5.0%, respectively, at 511 keV. The timing resolution of a single MPPC coupled to a LSO crystal was found to be 857 ps FWHM, and the value for the central region of detector module was 1182 ps FWHM when +/-10% energy window was applied. The nonlinear response of a single MPPC when used to read out a single LSO was observed among the corner crystals of the proposed detector module. However, the central region of the detector module exhibits significantly less nonlinearity (6.5% for 511 keV). These results demonstrate that (1) a charge-sharing resistor network can effectively multiplex MPPC signals and reduce the number of output signals without significantly degrading the performance of a PET detector and (2) a custom light guide to permit light sharing among multiple MPPC and to diffuse and direct scintillation light can reduce the nonlinearity of the detector response within the limited dynamic range of a typical MPPC. As a result, the proposed PET detector module has the potential to be refined for use in high-resolution PET insert applications.

Evaluation of Modular J-PET sensitivity

A Design Implementation of the Central Process Module for an In-Beam PET in HICTD

Simulating NEMA characteristics of the modular total-body J-PET scanner -- an economic total-body PET from plastic scintillators

Realistic Total-Body J-PET Geometry Optimization -- Monte Carlo Study

Development of the normalization method for the first large field-of-view plastic-based PET Modular scanner

Comparative studies of plastic scintillator strips with high technical attenuation length for the total-body J-PET scanner

Feasibility of the J-PET to monitor range of therapeutic proton beams

Investigation of Novel Preclinical Total Body PET Designed With J-PET Technology:A Simulation Study

Comparative studies of the sensitivities of sparse and full geometries of Total-Body PET scanners built from crystals and plastic scintillators

Feasibility of the J-PET to monitor the range of therapeutic proton beams

Evaluation of a Prototype of New Position-Sensitive Detector for a Small Animal PET System

Development of the front-end electronics for a cost-effective PET-like detector system

Study of a Prototype VP-PET Imaging System Based on highly Pixelated CdZnTe Detectors

Characterization in Geant4 of different PET configurations

A sub-millimeter resolution PET detector module using a multi-pixel photon counter array

Construction and evaluation of a large radiation detector for Positron Emission Tomography applications

A Finely Segmented Semi-Monolithic Detector tailored for High Resolution PET

Feasibility Study of a Small Animal PET Insert Based on a Single LYSO Monolithic Tube

Validation of the design of a high-sensitivity and high-resolution PET system for a preclinical PET/EPR hybrid scanner

Optimization of a depth of interaction encoding PET block detector for a PET/MRI insert

Multigap RPC for PET: development and optimisation of the detector design