Abstract:In this study, an effort was made to enhance the mechanical properties of coal-based synthetic natural gas slag (CSNGS) geopolymer with curing at ambient temperature by incorporating ground granulated blast furnace slag (GBFS). The effects of GBFS content, activator modulus and alkali content on the compressive strength of CSNGSGBFS (CG) geopolymers were analyzed, and the microstructural characteristics and the compositional evolution of reaction products were also investigated by X-ray diffraction (XRD), scanning electron microscope-energy dispersive spectrometer (SEM/EDS), Fourier transform infrared spectroscopy (FT-IR), and thermogravimetric analyzer (TG) tests. It was found that the mechanical properties of CG geopolymers was highly dependent on the of GBFS content. When the GBFS content was 50%, the 1-day and 28-day strengths of the geopolymer were 50.8 MPa and 120.2 MPa, respectively. Increasing alkali content resulted in the strength of geopolymer to increase and then decrease, whereas, the strength of geopolymer increased monotonically with a decrease in activator modulus. The results also showed that with increasing the GBFS contents, the characteristic peaks corresponding to the gels in the XRD patterns became gradually obvious with highly denser microstructures formed by a number of gels in the SEM micrographs, and the Ca/Si ratio and Ca/(Si + Al) ratio of the reaction products were increased, revealing that the gels generated in CG geopolymers was a mixture of N-A-S-H and C-(A)-S-H gels, which corroborated with the observed the stretching vibration of Si-O-T (T = Si or Al) in FT-IR spectrum shifted from 1013 cm-1 to 990 cm-1 and the corresponding temperatures of the mass loss peaks increased form 104 degrees C-114 degrees C. In addition, the dissolution of raw materials was promoted owing to the reduction of the activator modulus, but the change of activator modulus had little effect on the thermal stability of the gels. These findings suggest that CSNGS has the potential to prepare high-strength geopolymers at ambient temperature, providing an attractive avenue for reducing the environmental impact of CSNGS and conserving natural resources.

Strength and microstructural analysis of geopolymer prepared with coal-based synthetic natural gas slag

Microstructural and Mechanical Properties of a High-Strength Geopolymer Based on Coal-Based Synthetic Natural Gas Slag Cured at Ambient Temperature

Investigation on Mechanical Properties and Microstructure of Coal-Based Synthetic Natural Gas Slag (CSNGS) Geopolymer

A Novel Raw Material for Geopolymers: Coal-based Synthetic Natural Gas Slag

Preparation of Coal Gasification Coarse Slag-Based Alkaline Activator and Its Activation Mechanism in Alkali-Activated Slag

Mechanical Properties and Microscopic Characterization of Coal-Based Synthetic Natural Gas Slag As Supplementary Cementitious Materials

Compressive and Flexural Properties of Ultra-Fine Coal Gangue-Based Geopolymer Gels and Microscopic Mechanism Analysis

Experimental Study on Performance, Hydration, and Sustainability of Coal Gasification Coarse Slag Based Geopolymers for Sustainable Environment

A Novel Coal Gasification Coarse Slag-Based Geopolymer: Influences of Physico-Chemical Coupling Activation on Its Properties, Microstructure, and Hazardous Material Immobilization

Mechanical behavior and microstructure evolution of slag-fly ash based geopolymer stabilized sand

Preparation, Properties and Mechanism of Slag based Geopolymer

Influence of liquid-to-solid ratios on properties and microstructure of coal gasification slag-based one-part geopolymer

Mechanical activation of coal gasification slag for one-part geopolymer synthesis by alkali fusion and component additive method

Investigation on the utilization of coal gasification slag in Portland cement: Reaction kinetics and microstructure

Microstructure Analysis and Effects of Single and Mixed Activators on Setting Time and Strength of Coal Gangue-Based Geopolymers

Synthesis and Performance Evaluation of Nano-Calcium Carbonate-Modified Geopolymers Incorporating Fly Ash and Manganese Slag: A Comprehensive Investigative Study

Preparation and Properties of Geopolymer from Blast Furnace Slag

Preparation and characterization of cementitious materials based on sulfuric-acid-activated coal gasification coarse slag

Geopolymerization kinetics of steel slag activated gasification coal fly ash: A case study for amorphous-rich slags

Geopolymer pervious concrete modified with granulated blast furnace slag: Microscale characterization and mechanical strength

Synergistic Preparation of Geopolymer Usining Electrolytic Manganese Residue, Coal Slag and Granulated Blast Furnace Slag