Abstract:Lightweight geopolymer can combine good physical and mechanical properties, good thermal and chemical stability, low CO 2 emission and low energy. The development of high strength lightweight geopolymer concrete for load-bearing structures is important to expand the application range of geopolymer. This paper presents an improvement study on the mechanical properties and pore structure of lightweight geopolymer concrete (LGC) by adding ground granulated blast-furnace slag (GGBFS). The effect of GGBFS content on the mechanical properties of LGC was analyzed, including ultimate compressive stress and elastic modulus. The variation in the microscopic pore structure of LGC with different GGBFS content was further analyzed by low-field nuclear magnetic resonance (LF-NMR) technology. The lightweight geopolymer concrete with different strength grades was proposed including LC20, LC30 and LC40. The results show that as the GGBFS content increases, the ultimate compressive stress and specific strength of LGC increase while the strain corresponding to peak stress decreases, which means that the mechanical properties and deformation resistance of LGC are improved. The CO 2 emissions of LGC are lower than that of cement-based lightweight concrete, which shows good sustainability. The results also show that the addition of GGBFS can produce more gel and reduce the volume proportion of capillary pores and air pores, resulting in the densification of the LGC. The recommended GGBFS contents corresponding to the strength grades of LC20, LC30 and LC40 are 0 ∼ 12.7 %, 12.7 % ∼ 24.6 % and 24.6 % ∼ 30%, respectively. The LGC has the characteristics of lightweight and high-strength, which has a potential application in civil engineering. Highlights [1] Mechanical properties and pore structure of LGC were improved by adding GGBFS. [2] The effect of GGBFS content on geopolymer concrete properties was discussed. [3] Effect of slag content on pore structure of geopolymer concrete were studied. [4] GGBGS content of geopolymer concrete with different strength grades was proposed.

Geopolymer pervious concrete modified with granulated blast furnace slag: Microscale characterization and mechanical strength

Compressive Strength and Chloride Resistance of Slag/Metakaolin-Based Ultra-High-Performance Geopolymer Concrete.

Experimental Study on the Flexural Fatigue Performance of Slag/fly Ash Geopolymer Concrete Reinforced with Modified Basalt and PVA Hybrid Fibers

Physical and mechanical properties and micro characteristics of fly ash-based geopolymer paste incorporated with waste Granulated Blast Furnace Slag (GBFS) and functionalized Multi-Walled Carbon Nanotubes (MWCNTs)

Mechanical behavior and microstructure evolution of slag-fly ash based geopolymer stabilized sand

Optimization of mechanical properties and pore structure of lightweight geopolymer concrete using GGBFS based on LF-NMR technology

Strength and microstructural analysis of geopolymer prepared with coal-based synthetic natural gas slag

Mechanical properties and microstructure of ground granulated blast furnace slag-based geopolymer reinforced with polyvinyl alcohol fibers

Multi-aspect engineering properties and sustainability impacts of geopolymer pervious concrete

Research on mix design and mechanical performances of MK-GGBFS based geopolymer pastes using central composite design method

Influence of GGBFS and silica fume on characteristics of alkali-activated Metakaolin-based concrete

Mechanical Properties of Fiber-Reinforced Permeable Geopolymer Concrete

Strength and Microstructural Characterization of Ferrochrome Ash- and Ground Granulated Blast Furnace Slag-Based Geopolymer Concrete

Interfacial Behavior of Slag, Fly Ash, and Red Mud-Based Geopolymer Mortar with Concrete Substrate: Mechanical Properties and Microstructure

Preparation and Properties of Porous Concrete Based on Geopolymer of Red Mud and Yellow River Sediment

Mechanical behaviour and permeability of geopolymer mortars

Properties and Cementation Mechanism of Geopolymer Backfill Paste Incorporating Diverse Industrial Solid Wastes

Shrinkage and Mechanical Properties of Fibre-Reinforced Blast Furnace Slag-Steel Slag-Based Geopolymer

Sustainable Utilization of Waste Pumice Powder in Slag-Based Geopolymer Concretes: Fresh and Mechanical Properties

Strength and Microstructure Characteristics of Blended Fly Ash and Ground Granulated Blast Furnace Slag Geopolymer Mortars with Na and K Silicate Solution

Preparation and curing method of red mud-calcium carbide slag synergistically activated fly ash-ground granulated blast furnace slag based eco-friendly geopolymer