Abstract:Owing to the growing environmental concerns, super-critical and ultra-supercritical coal-fired power plants dominate the electricity generation with the demand of near-zero air pollutant emission in China. Therefore, it is highly expected to assess the environmental impact and optimize the design at global and local levels. Exergoenvironmental analysis is a valid approach to investigate the formation of environmental impacts (EIs) associated with energy conversion systems at the component level. It generates information crucial for designing systems with a lower overall environmental impact, based on life cycle assessment (LCA) and exergy analysis. A 600 MW supercritical coal-fired system with and without dust, SO2 and NOx mitigation controls was analyzed. Heat transfer in the boiler, condenser(CND), low pressure cylinder(LP), air preheater(APH) show high potential to decrease the environmental impact due to high exergy destructions. The deaerator (DEA), induced draft fan(IDF), forced draft fan(FDF) should be focussed on construction design and manufacturing optimization. Purification units reveal high benefit for reducing EI produced by coal combustion, but there is a large space for the EI saving for it. The specific EI of electricity in China is much greater than European.

Development of preliminary design of the energy system of the Ningdong, Ningxia thermal power plant

Circulating Efficiency Test of Domestic 600MW Units and Their Performance Optimization Analysis

Preliminary Design of Electric Part of Thermoelectric Unit in a Power Plant

Incorporate Design of SWH System with High-Rise Residential Building in Northern Guangxi Province - Principle of Design and Calculation

ANALYSIS ON THE PERFORMANCE OF COMPOSITE HEAT-ACCUMULATION AND POWER-GENERATION TECHNOLOGY IN THERMAL POWER PLANT

Parameters analysis of 600 MW + 120 MW peak load unit by integrated generate technology

Advanced Exergoenvironmental Evaluation for a Coal-Fired Power Plant of Near-Zero Air Pollutant Emission

An Innovative Heating Energy System Planning and Design: Case of Yinchuan City

MODEL TEST AND NUMERICAL ANALYSIS OF FLOW FIELD IN SCR DENITRIFICATION SYSTEM IN SECOND-PHASE PROJECT OF SANHE POWER PLANT

Design and Practice of Flue Gas Deep Cooling Device for Energy Saving and Emission Reduction

Design and Development of the Data Acquisition and Analysis System for the Provincial Combined Heat and Power Plants

Design and Application of Wind Farms Dispatching and Management Technical Support System in Inner Mongolia Power Grid

Electrical design of 4×50MW small thermal power plant

Study on Improving Consumption Capability of Wind Power by Installing Thermal Storage in Ningxia Province

Design and Development of Modern Simulation Systems for Thermal Power Generating Unit

Thermal and Electric Characteristic Design for Distributed Power Systems

Analysis and optimized measures for the energy conservation and consumption reduction of 600 MW thermal power units

Optimal Design Method of Direct Air-cooling System for Thermal Power Plants

Application analysis of distributed combined cooling heating and power system based on gas internal combustion engine

Design and Optimization of the Deaerator Steam Supply in Power Plant

Template guidelines for the preparation of the final paper study and application of peak-load regulating capacity for heating unites