Abstract:The utilization of numerical analytic techniques has become essential in evaluating the environmental consequences of excavation in foundation pits. The careful selection of suitable soil constitutive models has significant importance in this regard. The Hardening Soil (HS) model has become widely utilized in the numerical analysis of foundation pits among the several models considered. The essence of a constitutive model is in the identification and determination of its calculation parameters. The stress–strain curve is derived by conducting triaxial testing, utilizing the inherent properties of the particle swarm optimization (PSO) technique. The objective function entails quantifying the disparity between stress–strain curves obtained from various parameters and experimental curves while iteratively searching for five crucial parameters of soil‐hardening models: effective internal friction angle φ, effective cohesion, failure ratio R f , stiffness level‐dependent power exponent, and standard triaxial‐drained test secant stiffness . The objective of this research is to create a computational software utilizing the Python programming language to execute PSO with the purpose of determining sets of five fundamental soil constitutive parameters. This research employs optimized parameters acquired from PSO to construct a numerical model for foundation pits and performs numerical computations. Accurate findings may be reached by comparing the measured deformation in the numerical simulation with that seen in actual foundation pits. The results demonstrate a high degree of consistency between the experimental curves and the five parameter combinations obtained through the PSO algorithm, with an error rate not exceeding 8.2%. Moreover, the optimized curves exhibit closer alignment with theoretical expectations. The settlement values calculated using a numerical model based on optimized parameters show only a 6.12% deviation from actual measurements while closely following the trend of the observed curve. This outcome has the potential to greatly alleviate the burden of conducting indoor tests and holds considerable practical value in engineering applications. The observable optimization impact of PSO also serves as evidence of its viability in improving soil constitutive parameters, providing new perspectives and sources of information for future progress in this domain.

Parameter calibration method of clustered-particle logic concrete DEM model using BP neural network-particle swarm optimisation algorithm (BP-PSO) inversion method

Parameter Estimation of Catalytic Cracking Model Using PSO Algorithm

A calibration framework for the microparameters of the DEM model using the improved PSO algorithm

Control Parameterization‐Based Adaptive Particle Swarm Approach for Solving Chemical Dynamic Optimization Problems

Parameter Calibration of the Angle of Repose of Particle Materials Based on Convolutional Neural Network

Numerical Simulation and Deformation Prediction of Deep Pit Based on PSO-BP Neural Network Inversion of Soil Parameters

Modelling of particle flow code geotechnical material parameter relationships based on orthogonal design and back propagation neural network

A hybrid algorithm of particle swarm optimization and finite element method to identify local mesoscopic damage of concrete-like materials

Method of soil-elastoplastic DEM parameter calibration based on recurrent neural network

BACK-ANALYSIS ON MICROMECHANICAL PARAMETERS OF SOIL MASS USING BP NEURAL NETWORK

PFC model parameter calibration using uniform experimental design and a deep learning network

Rock Macro–Meso Parameter Calibration and Optimization Based on Improved BP Algorithm and Response Surface Method in PFC 3D

Calibration of discrete meta-parameters of bamboo flour based on magnitude analysis and BP neural network

Inversion Analysis of the In Situ Stress Field around Underground Caverns Based on Particle Swarm Optimization Optimized Back Propagation Neural Network

The investigation into the failure criteria of concrete based on the BP neural network

A methodology for parameter identification and calibration of the cohesive element based meso-scale concrete model

Automatic calibration of a discrete element model of a masonry arch by swarm intelligence methods

Efficient optimization parameter calibration method-based DEM simulation for compacted loess slope under dry-wet cycling

Research and verification on parameter solution of mixed shock model for common cause failure based on particle swarm algorithm

Microparameters Calibration for Discrete Element Method Based on Gaussian Processes Response Surface Methodology

Multiple Parameters Determination Method of Hardening Soil Model Based on Particle Swarm Optimization