Abstract:In the research and development of technology and equipment for bamboo products deep processing, such as filling, drying, and medicinal use of bamboo flour (BF), the poor compaction and fluidity of BF materials entails the need for accurate discrete element model (DEM) and BF parameters to provide a reference for the simulation of BF processing operationsand the development of related equipment. The average particle size of the 5 types of BFs ranges from 0.136 mm to 0.293 mm, and the small particle size of BF particles causes to the number of BF particles in bamboo processing equipment to reach tens of millions or even billions. When conventional methods are used for simulation, ordinary computers cannot provide the required computing power. To address the aforementioned challenges, this paper proposes a calibration method for the discrete element contact parameters of BFs based on dimensional analysis and a back propagation (BP) neural network. Using particle scaling theory and dimensional analysis methods, the average particle size of the BF was increased to 1 mm, and the main discrete element contact parameters of the five types of BF to be tested were used as input layers. The injection method and sidewall collapse method were used to obtain the angle of repose (AR) as the output layer. Fifty groups were randomly selected using MATLAB for EDEM simulation, and the simulation results were trained using the BP neural network algorithm; an ideal neural network model was obtained, the discrete element parameters of different BFs were predicted, and physical experiments were performed to verify two types of AR and mold hole compression under calibrated parameters. The relative error between the simulated AR obtained through calibration parameters and the physical experimental values is less than 2.3%. Through BF parameter validity verification, the simulated maximum compression displacement and compression ratio after stabilization were 34.81 mm and 0.477, which were close to the actual experimental results of 34.77 mm and 0.461, respectively, verifying the accuracy of the neural network prediction model. The research results provide a reference for the simulation of BF processing operations and the development of related equipment.

Parameter Calibration of the Angle of Repose of Particle Materials Based on Convolutional Neural Network

A Robot Calibration Method Based on Joint Angle Division and an Artificial Neural Network

A Calibration-Informed Deep Learning Model for Three-Dimensional Particle Reconstruction of Volumetric Particle Image Velocimetry

Method of soil-elastoplastic DEM parameter calibration based on recurrent neural network

PFC model parameter calibration using uniform experimental design and a deep learning network

Parameter Calibration and Verification of Elastoplastic Wet Sand Based on Attention-Retention Fusion Deep Learning Mechanism

Adaptive Residual Convolutional Neural Network for Compressive Strength Prediction of Energetic Materials Using SEM Images

Modelling of particle flow code geotechnical material parameter relationships based on orthogonal design and back propagation neural network

Parameter calibration method of clustered-particle logic concrete DEM model using BP neural network-particle swarm optimisation algorithm (BP-PSO) inversion method

Calibration of discrete meta-parameters of bamboo flour based on magnitude analysis and BP neural network

The potential of a multi-fidelity residual neural network based optimizer to calibrate DEM parameters of rock-like bonded granular materials

Effect of model architecture and input parameters to improve performance of artificial intelligence models for estimating concrete strength using SonReb

DEM Parameter Calibration of Maize Seeds and the Effect of Rolling Friction

An iterative method to improve the calibration accuracy of flat-joint models: Catch-up penalty algorithm

Calibration Of The Microparameters Of Rock Specimens By Using Various Machine Learning Algorithms

Calibration of Discrete Element Method Parameters for a High-Fidelity Lunar Regolith Simulant Considering the Effects of Realistic Particle Shape

Friction coefficient calibration of corn stalk particle mixtures using Plackett-Burman design and response surface methodology

Interpretable Calibration of Crystal Plasticity Model Using a Bayesian Surrogate-Assisted Genetic Algorithm

Prediction of material removal rate in chemical mechanical polishing via residual convolutional neural network

Prediction of high-performance concrete compressive strength through novel structured neural network

Investigating Deep Learning Model Calibration for Classification Problems in Mechanics