Abstract:The utilization of numerical analytic techniques has become essential in evaluating the environmental consequences of excavation in foundation pits. The careful selection of suitable soil constitutive models has significant importance in this regard. The Hardening Soil (HS) model has become widely utilized in the numerical analysis of foundation pits among the several models considered. The essence of a constitutive model is in the identification and determination of its calculation parameters. The stress–strain curve is derived by conducting triaxial testing, utilizing the inherent properties of the particle swarm optimization (PSO) technique. The objective function entails quantifying the disparity between stress–strain curves obtained from various parameters and experimental curves while iteratively searching for five crucial parameters of soil‐hardening models: effective internal friction angle φ, effective cohesion, failure ratio R f , stiffness level‐dependent power exponent, and standard triaxial‐drained test secant stiffness . The objective of this research is to create a computational software utilizing the Python programming language to execute PSO with the purpose of determining sets of five fundamental soil constitutive parameters. This research employs optimized parameters acquired from PSO to construct a numerical model for foundation pits and performs numerical computations. Accurate findings may be reached by comparing the measured deformation in the numerical simulation with that seen in actual foundation pits. The results demonstrate a high degree of consistency between the experimental curves and the five parameter combinations obtained through the PSO algorithm, with an error rate not exceeding 8.2%. Moreover, the optimized curves exhibit closer alignment with theoretical expectations. The settlement values calculated using a numerical model based on optimized parameters show only a 6.12% deviation from actual measurements while closely following the trend of the observed curve. This outcome has the potential to greatly alleviate the burden of conducting indoor tests and holds considerable practical value in engineering applications. The observable optimization impact of PSO also serves as evidence of its viability in improving soil constitutive parameters, providing new perspectives and sources of information for future progress in this domain.

A calibration framework for the microparameters of the DEM model using the improved PSO algorithm

Parameter Estimation of Catalytic Cracking Model Using PSO Algorithm

A calibration framework for DEM models based on the stress‒strain curve of uniaxial compressive tests by using the AEO algorithm and several calibration suggestions

Parameter calibration method of clustered-particle logic concrete DEM model using BP neural network-particle swarm optimisation algorithm (BP-PSO) inversion method

Control Parameterization‐Based Adaptive Particle Swarm Approach for Solving Chemical Dynamic Optimization Problems

Kinematic Calibration for Articulated Arm Coordinate Measuring Machines Base on Particle Swarm Optimization

Microparameters Calibration for Discrete Element Method Based on Gaussian Processes Response Surface Methodology

Calibration of the microparameters of the discrete element method using a relevance vector machine and its application to rockfill materials

Calibration Of The Microparameters Of Rock Specimens By Using Various Machine Learning Algorithms

Experimental Simulation and a Reliable Calibration Method of Rockfill Microscopic Parameters by Considering Flexible Boundary

Calibrating the Micromechanical Parameters of the PFC2D(3D) Models Using the Improved Simulated Annealing Algorithm

An iterative method to improve the calibration accuracy of flat-joint models: Catch-up penalty algorithm

A DEM parameters calibration method for three-dimensional model of the lunar rock based on the approximate model

Calibration of Discrete Element Method Parameters for a High-Fidelity Lunar Regolith Simulant Considering the Effects of Realistic Particle Shape

Multiple Parameters Determination Method of Hardening Soil Model Based on Particle Swarm Optimization

Measurement and Simulation Validation of DEM Parameters of Pellet, Sinter and Coke Particles

A Modified PSO Algorithm with Dynamic Parameters for Solving Complex Engineering Design Problem

Measurement and calibration of DEM parameters of lunar soil simulant

Calibration of the Discrete Element Method and Modeling of Shortening Experiments

Mathematical Modeling and Parameter Optimization of Fine Particle Sensors Based on Laser Light Scattering

Method of soil-elastoplastic DEM parameter calibration based on recurrent neural network