Abstract:Abstract Automotive engine downsizing has placed an increased focus on the ability of the turbocharger to provide adequate boost levels across the full engine operating rage. To achieve the desired levels of turbocharger performance the turbine must be capable of operating effectively at the intended design point and also at off-design conditions. Mixed flow turbines (MFTs) provide a potential method to improve performance at off-design conditions and during transient engine operation. A unique feature of a MFT is the spanwise variation of incidence angle at the rotor leading edge. This results in additional flow separation from the blade suction surface near the hub under a wide range of operating conditions. The flow separation generates additional loss and has a detrimental impact on turbine performance. A novel design of turbine volute similar to a conventional twin-entry turbine volute was examined. The novel turbine volutes were designed to produce a spanwise variation in flow conditions at the rotor inlet. The primary objective was to reduce the incidence angle and increase the mass flow rate at the hub side of the passage relative to the shroud side, as it has previously been identified that this can be beneficial for MFT performance. A number of different volute geometries were examined by numerical analysis to determine the impact of key parameters on turbine performance. The results indicated that generating a suitable spanwise flow distribution could produce a moderate improvement in turbine efficiency at off-design operating conditions. The novel volute design also provided a means of achieving a degree of variable geometry operation to further improve off-design performance. Turbine performance was examined under the variable geometry operation and an improvement in turbine power output at low speed, off-design conditions was achieved. This was analogous to operating with a conventional pivoting vane variable geometry system and had the potential to benefit performance during transient engine operation.

The design and validation of over/under turbine-based combined cycle inlet

Performance Analysis of Dual-Channel Inward-Turning Inlets under Off-Design Conditions

Modeling and mode transition simulation of over-under turbine based combined cycle (TBCC) propulsion system based on inlet/engine matching

Multi-fidelity simulation of inlet mode transition with smooth thrust of turbine based combined cycle

Performance of a Jaws Inlet under Off-Design Conditions

Design Procedure of a Variable Rectangular Inlet for TBCC Engine Considering Mass Flow Requirements

Investigation of translation scheme turbine-based combined-cycle inlet mode transition

Analysis of the impact of key similarity criteria numbers of TBCC inlet during the mode transition

Design and examination of a turboprop inlet with scavenge duct

Aerodynamic Optimization of Turbine Based Combined Cycle Nozzle

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

Research on the Criteria for Determining the Starting Performance of an Inward-Turning Inlet by Integrating the Concept of the Equivalent Contraction Ratio

An Aerodynamic Design and Numerical Investigation of Transonic Centrifugal Compressor Stage

Numerical research on the aerodynamic performance of inlet volute duct for a heavy-duty gas turbine

The Numerical Simulation of Gas Turbine Inlet-Volute Flow Field

Design Criterion for Asymmetric Twin-Entry Radial Turbine for Efficiency under Steady and Pulsating Inlet Conditions

Turbojet Module Sizing for Integration with Turbine-Based Combined Cycle Engine

Flow response hysteresis of throat regulation process of a two-dimensional mixed-compression supersonic inlet

Monte Carlo Simulation of Inlet Flows in Atmosphere-Breathing Electric Propulsion

Inlet Duct Treatment for Stability Improvement on a High Pressure Ratio Centrifugal Compressor

Investigation of a Novel Turbine Housing to Produce a Non-Uniform Spanwise Flow Field at the Inlet to a Mixed Flow Turbine and Provide Variable Geometry Capabilities