Abstract:In a boundary layer ingestion (BLI) propulsion system, the compressor rotor operates under the condition of a severe inflow distortion because the boundary layers on the surface of aircraft have been ingested. In this situation, the low-momentum fluid would inevitably raise the blade load and aggravate the local aerodynamic losses, thus severely deteriorating the compressor overall aerodynamic performance. The paper has applied a sweep optimization design based on surrogate model and genetic algorithm to a transonic axial-flow compressor at the condition of total pressure distorted inflow. The optimization objective is to improve the compressor efficiency. The sweep design has been implemented through controlling the shape of the blade stacking line and the time-saving steady numerical simulations are mainly utilized in the optimization process. Then, the full-annulus unsteady CFD calculations have been conducted for validating the optimized design and further analyzing the flow mechanisms of performance improvements. The computational results show that the inflow distortion has led to non-uniform distributions of the tip leakage loss and the hub flow separation loss along the circumferential direction. It is found that the rotor blade has suffered from the highest tip leakage losses and hub separation losses during the blade leaving the distorted region. After rotor sweep optimization, both tip leakage and hub separation losses have been notably reduced along the full circumferential direction. Moreover, for different pitchwise locations, the optimized rotor sweep design has achieved more aerodynamic performance improvements in the process of the rotor blade leaving the distorted region than those in the processes of the rotor blade moving out of, moving towards and entering the distorted region. Overall, the optimized design performs better than the baseline design in terms of adiabatic efficiency in the entire operating range. In the meanwhile, the total pressure ratio has been maintained. Specifically, an approximately 0.5% increment of efficiency has been achieved by the optimized design at the optimization point. For this paper, the major purpose is to offer useful guidelines for fan/compressor design strategy to achieve high aerodynamic performances under distorted inflow working condition.

Fast Multi-Objective Optimization Design of Gas Turbine L-inlet Duct

A Fast Multiobjective Optimization Approach to S-duct Scoop Inlets Design with Both Inflow and Outflow

Optimization Design for Supersonic Inlet Structure Parameter

Optimization Design of Aspect Ratio and Solidity of a Heavy-Duty Gas Turbine Transonic Compressor Rotor

Pressure Drop Analysis and Aerodynamic Design of Compressor L-inlet Duct

Numerical research on the aerodynamic performance of inlet volute duct for a heavy-duty gas turbine

A Combinatorial Optimization Design Method Applied to S-shaped Compressor Transition Duct Design

Using an Optimisation Strategy to Design a Supercritical CO2 Radial Inflow Turbine Transonic Stator

Multidisciplinary Design and Multi-Objective Optimization on Guide Fins of Twin-Web Disk Using Kriging Surrogate Model

Design and Optimization of Half Flush-Mounted S-Shaped Inlet

Parameterization and Optimization Design of a Two-Dimensional Axisymmetric Hypersonic Inlet

Design performance evaluation and vortex structure investigation of different S-shaped intermediate turbine ducts

Design of Shape Morphing Hypersonic Inward-Turning Inlet Using Multistage Optimization

Genetic optimization design for aerodynamic structure of oblique flow compressor radial inlet chamber in compressed air energy storage system

Analysis on the Low Speed Performance of an Inward-Turning Multiduct Inlet for Turbine-Based Combined Cycle Engines

Multi-objective Optimization of the Flush-Type Intake Duct for a Waterjet Propulsion System

Optimization of a Transonic Axial-Flow Compressor under Inlet Total Pressure Distortion to Enhance Aerodynamic Performance

Experimental and numerical study on aerodynamic stability of compressor L-inlet duct

Comparison of Turbine Low Pressure Guide Vane before and After Optimization

Optimization of Turbine Blade Trailing Edge Cooling Using Self-Organized Geometries and Multi-Objective Approaches

Aerothermodynamics Optimal Design of a Multistage Axial Compressor in a Gas Turbine Using Directly Manipulated Free-Form Deformation