Abstract:Abstract Turbojet and turbofan engine propulsion system are extensively used in aircraft. Turbojets have simple engine design and extensively used for supersonic flights. Turbofan engine has high mass flow rate and efficient for subsonic application. Variable Cycle Engines, unlike the traditional engines, can vary between high thrust mode for supersonic operations and high efficiency mode for subsonic operations hence are potentially attractive for supersonic transport and advanced tactical fighter aircraft. Variable Cycle Engine can be described as the one that operates with two or more cycles, could serve as a possible solution to reconciling the necessary performance at different operating conditions. The aim of the engine is to combine the best traits of turbojet (high specific thrust) and turbofan (low specific fuel consumption, low noise). Traditional engines have fixed mass flow but VCE can alter the mass flow and function as high bypass engine for the subsonic case and low bypass engine at the supersonic case. Different variable cycle engine design philosophies were studied and the engine architecture used in F120 was incorporated into the base design of a low bypass ratio Turbofan Engine. Cycle analysis of VCE was primarily done based on theoretical calculation and parametric study performed with the use of Gasturb software. Two Variable Area Bypass Injectors (VABI) were used to vary the mass flow through the core and the bypass stream. We aspire to achieve enhanced performance at subsonic and supersonic mission segments. Subsonic, supersonic and take off conditions were decided and the base engine was modified to have multiple operating points. The VCE combines two cycles (subsonic, supersonic) in same engine body and it is crucial for the engine components to deliver the required performance at both the design points. The engine design procedure consists of the matching of components like turbine, compressor, exhaust nozzle and the exhaust mixing area. Systematic study of turbine matching for such engine configuration with multiple operating points was carried out to understand the utility of variable geometry in a VCE. For turbine matching, the mass flow through turbine was held constant by adjusting the VABIs and this was repeated for different takeoff conditions to analyses the output in detail. The non dimensional mass flow through the turbine was fixed for both the design points and hence the turbine could be designed to provide high efficiency. The fuel consumption was found to have decreased compared to the baseline condition which in turn leads to low SFC and higher endurance.

Turbojet Module Sizing for Integration with Turbine-Based Combined Cycle Engine

Conceptual Design and Optimization of Scramjet Engines Using the Exergy Method

Parametric Study for Adoption of Variable Cycle Engine Concept for Low Bypass Ratio Turbofan Engine

Thrust-matching and optimization design of turbine-based combined cycle engine with trajectory optimization

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Integrated Design Of A Variable Cycle Engine And Aircraft Thermal Management System

Design Procedure of a Variable Rectangular Inlet for TBCC Engine Considering Mass Flow Requirements

Flight trajectory optimization study of a variable-cycle turbine-based combined cycle engine hypersonic vehicle based on airframe/engine integration

Performance Analysis and Dynamic Optimization of Integrated Cooling and Power Generation System Based on Supercritical CO2 Cycle for Turbine-Based Combined Cycle Engine

Aerodynamic Optimization of Turbine Based Combined Cycle Nozzle

Design and Analysis of an Aircraft Thermal Management System Linked to a Low-Bypass Ratio Turbofan Engine

The design and validation of over/under turbine-based combined cycle inlet

Research on an optimization design method for a TBCC propulsion scheme

Turbo-Cool Turbocharging System for Spark Ignition Engines

Mode transition path optimization for turbine-based combined-cycle ramjet stage under uncertainty propagation of integrated airframe-propulsion system

Variable Cycle Optimization for Supersonic Commercial Applications

Modeling and Performance Analysis of a Pre-Cooling and Power Generation System Based on the Supercritical CO2 Brayton Cycle on Turbine-Based Combined Cycle Engines

Multi-fidelity simulation of inlet mode transition with smooth thrust of turbine based combined cycle

Design space investigations of scramjet engines using reduced-order modelling

Design optimization and off-design performance analysis of axisymmetric scramjet intakes for ascent flight

Modeling and Simulation of a Dynamic Turbofan Engine Using Simulink