3D spatial fracture behavior of sandstone containing a surface flaw under uniaxial compression
Zhenyu Han,Jianchun Li,Diyuan Li,Jian Zhao
DOI: https://doi.org/10.1016/j.ijrmms.2023.105583
IF: 6.849
2023-01-01
International Journal of Rock Mechanics and Mining Sciences
Abstract:Surface defects are prevalent in natural rock masses, and the newborn cracks that initiate from these defects and significantly affect structural stability usually extend in a three-dimensional (3D) manner. Hence, in this research, a series of uniaxial compression tests were conducted on sandstone specimens containing a surface flaw to examine the effect of nondimensional flaw depth (0, 0.3, 0.5 and 0.75) on the fracture behavior. The crack propagation process was monitored by digital image correlation (DIC) technique, and postmortem microscopic fracture morphology was measured using scanning electron microscope (SEM) method. In addition, the fracture energy evolution and stress intensity factors (SIFs) along the semi-elliptical flaw perimeter were discussed in detail to theoretically interpret the experimental phenomena. The results indicate that the strength decreased by 2.70%, 10.90% and 11.91% for nondimensional surface flaw depths of 0.3, 0.5 and 0.75, respectively, and elastic modulus exhibited a reduction of 3.71%, 10.69% and 3.21%, respectively. Full-field deformation contours demonstrate that crack paths in the front surface of the specimen were totally different from those in the back surface, but the failure pattern tended to be similar to that of specimens containing a penetrated flaw with the increasing flaw depth. The micro appearance of a typical fracture further reveals the complicated stress state (mixed I-II-III mode) under uniaxial compression. For a larger flaw depth, the proportion of releasable elastic strain energy in total input strain energy was improved, while the percentage of dissipated energy was reduced. Based on fracture mechanics, SIFs along the flaw periphery uncover the magnitude of KI, KII and KIII and further the type of initiation crack type. Finally, parametric analysis was carried out to investigate the effects of flaw length and specimen thickness. The difference in crack pattern from surface and penetrated flaw was also discussed in detail.