Abstract:To understand the fracture coalescence in specimens containing oval flaws, PFC2D was used to investigate the sandstone containing two oval flaws with different ligament angles under uniaxial compression. The micro-parameters were first confirmed by intact sandstone, and then, these were adopted to simulate the flawed specimen under uniaxial compression. Numerical results show that the peak strength, the peak strain, elastic modulus, and the ultimate failure modes were approximated well with these obtained by experiment. The failure modes obtained by numerical simulation can be divided into the following four typical categories based on the crack coalescence between the pre-existing flaws: no crack coalescence; indirect crack coalescence outside the bridge area; single crack coalescence inside the bridge area; tensile crack coalescence outside the bridge area. Based on parallel bond force fields and stress variation of measurement circles along the crack trajectory, the crack evolution processes were analyzed in detail and crack types were identified. The mode III can be divided into mode IIIa and mode IIIb. The mode IIIa is the single shear crack coalesced inside the bridge area; the mode IIIb is the single crack that initiated with tensile crack and coalesced with shear crack, and it only occurred as β = 90°. The mode IV can be divided into mode IVa and mode IVb. The mode IVa is that wing crack initiated at the middle of oval and coalesced at another oval tip, and it occurred as β = 120°. The mode IVb is that coalesced with anti-wing crack outside the bridge area, and it occurred as β = 150°. The stress distribution along the ligament has an obvious effect on ligament angle and flaw angle, and crack initiation only affects the stress concentration factor value.

Fracture behavior of cylindrical sandstone specimens with two pre-existing flaws: experimental investigation and PFC3D simulation

Experimental and DEM study on failure behavior and stress distribution of flawed sandstone specimens under uniaxial compression

Cracking Behavior and Acoustic Emission Characteristics of Rock Containing a Single Preexisting Flaw

Numerical Study of Failure Behaviour of Pre-Cracked Rock Specimens under Conventional Triaxial Compression

Discrete element modeling on crack evolution behavior of sandstone containing two oval flaws under uniaxial compression

Investigation on Fracture Mode and Initiation Mechanisms of Cracks in Sandstone Disk Containing a Preexisting Flaw

Numerical Study of the Strength and Characteristics of Sandstone Samples with Combined Double Hole and Double Fissure Defects

Numerical investigation on the influence of secondary flaw lengths on the mechanical characteristics and cracking behaviour of red sandstone containing orthogonal cross flaws

3D Digital Analysis of Cracking Behaviors of Rocks through 3D Reconstruction Model under Triaxial Compression

Numerical Study on Cracking Behavior and Fracture Failure Mechanism of Flawed Rock Materials under Uniaxial Compression

Experimental and numerical studies of brittle rock-like specimens with unfilled cross fissures under uniaxial compression

Deformation localization and crack propagation of sandstone containing different flaw inclination angles under different loading rates

Systematic detection and evaluation of cracking behavior of flawed brittle sandstones with AE and 3D-DIC techniques

Experimental and numerical study on the mechanical behaviors and crack propagation of sandstone containing two parallel fissures

Quantitative investigation of the cracking mechanism of 3D sand-printed rock containing a fold flaw

Cracking Evolution and Failure Mechanism of Brittle Rocks Containing Pre-Existing Flaws under Compression-Dominating Stresses: Insight from Numerical Approach

Numerical and Experimental Assessment of the Sandstone Fracture Mechanism by Non-uniform Bonded Particle Modeling

Experimental investigation on mechanical, acoustic, and fracture behaviors and the energy evolution of sandstone containing non-penetrating horizontal fissures

Numerical study on full-field stress evolution and acoustic emission characteristics of rocks containing three parallel pre-existing flaws under uniaxial compression

Quantitative description of fracture behavior and mechanical anisotropy of fractured rock mass: Sand 3D printing and DIC explorations

Effect of fractures on mechanical behavior of sand powder 3D printing rock analogue under triaxial compression