Abstract:A fundamental understanding of interactions between catalysts and gas molecules is essential for the development of efficient heterogeneous catalysts. In this study, ambient pressure X-ray photoelectron spectroscopy (APXPS) and density functional theory (DFT) simulation were employed to investigate the activation of CO2 on Cu surfaces, which acts as a key step in the catalytic reduction of CO2. APXPS results show that CO2 is adsorbed as CO2 delta- on the Cu(111) surface under a pressure of 0.01 mbar at 300 K. Adsorbed CO2 delta- gets partially transformed into carbonate with an increase of pressure to 1 mbar due to the disproportionation reaction between CO2 molecules. Subsequent annealing of the Cu(111) surface in a CO2 atmosphere leads to the dissociation of CO2 delta- and carbonate, and a transformation to a chemisorbed oxygen covered surface occurred at 400 K and elevated temperatures. However, on the Cu(110) surface, the CO2 delta- gradually dissociates to CO and chemisorbed oxygen in the presence of 1 mbar of CO2 at room temperature. The self-deactivation of CO2 adsorption due to the atomic oxygen generated by CO2 dissociation is observed on both Cu(111) and Cu(110) surfaces. Moreover, these experimental results indicate that the Cu(110) surface is more active than the Cu(111) surface in breaking C-O bonds, which is consistent with the results of DFT simulations. Our findings indicate that the activation of CO2 on Cu surfaces is strongly surface orientation- and pressure-dependent, which is an important step to clarify CO2 activation mechanisms on Cu-based catalysts.

Characterization of CO Adsorbed to Clean and Partially Oxidized Cu(211) and Cu(111)

Direct Spectroscopic Comparison of CO Adsorption over CuOx Prepared In Situ

CO adsorption and oxidation on oxygen precovered Cu(110) at 150 K: reactivity of two types of adsorbed atomic oxygen determined by scanning tunneling microscopy

Site‐Resolved Cu2O Catalysis in the Oxidation of CO

Interfacial Cu+ promoted surface reactivity: Carbon monoxide oxidation reaction over polycrystalline copper–titania catalysts

Catalytic Intermediates Of Co2 Hydrogenation On Cu(111) Probed By In Operando Near-Ambient Pressure Technique

Stable Pt Single Atoms and Nanoclusters on Ultrathin CuO Film and Their Performances in CO Oxidation

Roughening of Copper (100) at Elevated CO Pressure: Cu Adatom and Cluster Formation Enable CO Dissociation

Surface Orientation and Pressure Dependence of CO2 Activation on Cu Surfaces

Reaction Mechanism for CO Oxidation on Cu(311): A Density Functional Theory Study

Imaging Catalytic Activation of CO2 on Cu2O (110): A First-Principles Study.

Initial Stages of Oxidation for Cu-based Catalysts Using Density Functional Theory

The Role of Cu‐oxide and Cu adatoms in the Reactivity of CO2 on Cu(110)

Redox-Mediated Reconstruction of Copper during Carbon Monoxide Oxidation

Unravelling CO adsorption on model single-atom catalysts

Self-Inhibition Phenomena in Cu3Pt Oxidation by CO2

Reaction Mechanism of CO Oxidation on Cu(2)O(111): A Density Functional Study.

In situ characterization of Cu-Co oxides for catalytic application

Cu Dimer Anchored on C2N Monolayer: Low-Cost and Efficient Bi-atom Catalyst for CO Oxidation.

Reaction mechanism for CO oxidation on Cu(3 1 1): A density functional theory study