Abstract:With the goal of finding low-cost materials that can completely substitute the precious- and noble-containing catalysts and be active toward the oxidation of CO at low temperatures (around 100 °C), transition metal oxide-doped cryptomelane (e.g., K-OMS-2, MeO x /K-OMS-2, and CuO x -MeO x /K-OMS-2; Me = Ni, Fe, Cd, Sn, Mn, Cr, Co, Zn, and Al) were obtained by the impregnation method with different synthesis conditions. The synthesized samples were then tested for CO conversion and characterized by means of powder X-ray diffraction, elemental mapping and composition, as well as scanning electron microscopy. It was demonstrated that the K-OMS-2 support doped by a composite of CuO x -NiO x (promoter) and calcined at 400 °C gave higher catalytic activity than the other samples, with a 90% CO conversion at around 120 °C. Other factors that could be controlled for increasing CuO x -NiO x /K-OMS-2_400 activity were to set the mass percentage of dopants and the atomic ratio of Cu:Ni to about 15 mass% and 1:1, respectively. Under different catalytic reaction conditions such as various inlet CO concentrations ( C CO , 750–4000 ppm), amounts of catalyst ( m cat , 0.25–1.25 g), and gas-air flow rates ( F gas , 0.5–1.25 L/min), the catalyst activity was found to be enhanced when the C CO and F gas were reduced and the m cat raised. Moreover, the CuO x -NiO x /K-OMS-2_400 catalyst exhibited high stability and durability. The calculated average size of K-OMS-2 crystallites was approximately 12 nm, while the composite phase was in its amorphous state. This sample showed a morphology of nanofiber-like shapes with different lengths.

Dynamic Study of the Oxidation State of Copper in the Course of Carbon Monoxide Oxidation over Powdered CuO and Cu2O

Understanding Oxidation State of Cu-based Catalysts for Electrocatalytic CO2 Reduction

Direct Spectroscopic Comparison of CO Adsorption over CuOx Prepared In Situ

Oxidation of carbon monoxide catalyzed by copper-zirconium composite oxides

Redox-Mediated Reconstruction of Copper during Carbon Monoxide Oxidation

Interfacial Cu+ promoted surface reactivity: Carbon monoxide oxidation reaction over polycrystalline copper–titania catalysts

CO Oxidation over Alumina-Supported Copper Catalysts

Mechanistic study of low-temperature CO oxidation over CuO/Cu2O interfaces with oxygen vacancy modification

CO oxidation over CuOx/TiO2 catalyst: The importance of oxygen vacancies and Cu+ species

Theoretical study on CO production mechanism from CO 2 reduction on Cu–catalyst surface with different oxidation states

Enhancing CO catalytic oxidation performance over Cu-doping manganese oxide octahedral molecular sieves catalyst

Enhancing the Catalytic Oxidation of Carbon Monoxide Using K-OMS-2 by Surface Modification with Binary Oxides of Copper and Other Metals

Large-scale Synthesis and Catalytic Activity of Nanoporous Cu–O System Towards CO Oxidation

Unraveling distinct effects between CuOx and PtCu alloy sites in Pt-Cu bimetallic catalysts for CO oxidation at different temperatures

Characterization of CO Adsorbed to Clean and Partially Oxidized Cu(211) and Cu(111)

Surface Structure Characteristics of CuO/Ti0.5Sn0.5O2 and Its Activity for CO Oxidation

CO2 Self-Poisoning and Its Mitigation in CuO Catalyzed CO Oxidation: Determining and Speeding up the Rate-Determining Step

Low-Temperature Co Oxidation Over Cuo/Co3o4 Catalysts

Catalytic oxidative properties and characterization of CuO/CeO2 catalysts

The Preferential Oxidation of CO in Excess Hydrogen: A Study of the Influence of KOH/K2CO3 on CuO–CeO2−x Catalysts