Abstract:Temperature-programmed reaction spectroscopy (TPRS) and direct, isothermal reaction-rate measurements were employed to investigate the oxidation of CO on Pt(111) covered with high concentrations of atomic oxygen. The TPRS results show that oxygen atoms chemisorbed on Pt(111) at coverages just above 0.25 ML (monolayers) are reactive toward coadsorbed CO, producing CO(2) at about 295 K. The uptake of CO on Pt(111) is found to decrease with increasing oxygen coverage beyond 0.25 ML and becomes immeasurable at a surface temperature of 100 K when Pt(111) is partially covered with Pt oxide domains at oxygen coverages above 1.5 ML. The rate of CO oxidation measured as a function of CO beam exposure to the surface exhibits a nearly linear increase toward a maximum for initial oxygen coverages between 0.25 and 0.50 ML and constant surface temperatures between 300 and 500 K. At a fixed CO incident flux, the time required to reach the maximum reaction rate increases as the initial oxygen coverage is increased to 0.50 ML. A time lag prior to the reaction-rate maximum is also observed when Pt oxide domains are present on the surface, but the reaction rate increases more slowly with CO exposure and much longer time lags are observed, indicating that the oxide phase is less reactive toward CO than are chemisorbed oxygen atoms on Pt(111). On the partially oxidized surface, the CO exposure needed to reach the rate maximum increases significantly with increases in both the initial oxygen coverage and the surface temperature. A kinetic model is developed that reproduces the qualitative dependence of the CO oxidation rate on the atomic oxygen coverage and the surface temperature. The model assumes that CO chemisorption and reaction occur only on regions of the surface covered by chemisorbed oxygen atoms and describes the CO chemisorption probability as a decreasing function of the atomic oxygen coverage in the chemisorbed phase. The model also takes into account the migration of oxygen atoms from oxide domains to domains with chemisorbed oxygen atoms. According to the model, the reaction rate initially increases with the CO exposure because the rate of CO chemisorption is enhanced as the coverage of chemisorbed oxygen atoms decreases during reaction. Longer rate delays are predicted for the partially oxidized surface because oxygen migration from the oxide phase maintains high oxygen coverages in the coexisting chemisorbed oxygen phase that hinder CO chemisorption. It is shown that the time evolution of the CO oxidation rate is determined by the relative rates of CO chemisorption and oxygen migration, R(ad) and R(m), respectively, with an increase in the relative rate of oxygen migration acting to inhibit the reaction. We find that the time lag in the reaction rate increases nearly exponentially with the initial oxygen coverage [O](i) (tot) when [O](i) (tot) exceeds a critical value, which is defined as the coverage above which R(ad)R(m) is less than unity at fixed CO incident flux and surface temperature. These results demonstrate that the kinetics for CO oxidation on oxidized Pt(111) is governed by the sensitivity of CO binding and chemisorption on the atomic oxygen coverage and the distribution of surface oxygen phases.

CO adsorption and oxidation on oxygen precovered Cu(110) at 150 K: reactivity of two types of adsorbed atomic oxygen determined by scanning tunneling microscopy

Structure of Co Monolayer on Cu(100)

The Atomic Structure and Electronic States of Oxygen- Adsorbed on Cu(110)c(2×1) Surface

The Role of Cu‐oxide and Cu adatoms in the Reactivity of CO2 on Cu(110)

Characterization of CO Adsorbed to Clean and Partially Oxidized Cu(211) and Cu(111)

Dissociative Adsorption of O2 on Clean and CO-Precovered Pt Surfaces

Structure of Reconstructed Cu(100) Surface Induced by Dissociative Adsorption of Gaseous Oxygen

Roughening of Copper (100) at Elevated CO Pressure: Cu Adatom and Cluster Formation Enable CO Dissociation

Kinetics of the CO Oxidation Reaction on Pt(111) Studied by in Situ High-Resolution X-Ray Photoelectron Spectroscopy.

The adsorption of CO on Cu(110)

Adsorbate–adsorbate repulsions—the coverage dependence of the adsorption structure of CO on Cu(110) as studied by electron‐stimulated desorption ion angular distribution

A Density Functional Theory Study on the Adsorption of Co and O-2 on Cu-Terminated Cu2o (111) Surface

Adsorption dynamics of CO on Cu(110): a molecular beam study

Adsorption of CO on Rutile TiO2 (110)-1 × 1 Surface with Preadsorbed O Adatoms

High‐Pressure‐Induced Pseudo‐oxidation of Copper Surfaces by Carbon Monoxide

Kinetics of CO oxidation on high-concentration phases of atomic oxygen on Pt(111)

Adsorption and Oxidation of CO on Co3O4/Ir(100) Thin Films

Direct Spectroscopic Comparison of CO Adsorption over CuOx Prepared In Situ

Co Adsorption on Pt (111) and Pd (111) Surfaces: A First-Principles Based Lattice Gas Monte-Carlo Study

The adsorption and decomposition of formic acid on Cu {110}

Adsorption and Reaction of CO on the Slightly Oxidized Mo(100) Surface