Abstract:This paper describes the results of experimental studies on heat transfer in a shell and tube heat exchanger during the phase changes of the HFE 7000 refrigerant. The studies were performed using a mixture of water and a microencapsulated phase change material as a coolant. HFE 7000 refrigerant condenses on the external surface of the copper tube, while a mixture of water and phase change materials flows through the channels as coolant. Currently, there is a lack of research describing cooling using phase change materials in heat exchangers. There are a number of publications describing the heat exchange in heat exchangers during phase changes under air or water cooling. Therefore, the research hypothesis was adopted that the use of mixed water and microencapsulated material as a heat transfer fluid would increase the heat capacity and contribute to the enhancement of the heat exchange in the heat exchanger. This will enable an increase in the total heat transfer coefficient and the heat efficiency of the exchanger. Experimental studies describe the process of heat transfer intensification in the above conditions by using the phase transformation of the cooling medium melting. The test results were compared with the results of an experiment in which pure water was used as the reference liquid. The research was carried out in a wide range of refrigerant and coolant parameters: ṁr = 0.0014–0.0015 kg·s−1, ṁc = 0.014–0.016 kg·s−1, refrigerant saturation temperature Ts = 55–60 °C, coolant temperature at the inlet Tcin = 20–32 °C, and heat flux density q = 7000–7450 W·m−1. The obtained results confirmed the research hypothesis. There was an average of a 13% increase in the coolant heat transfer coefficient, and the peak increase in αc was over 24%. The average value of the heat transfer coefficient k increased by 5%, and the highest increases in the value of k were noted at Tin = 27 °C and amounted to 9% in relation to the reference liquid.

Experimental Investigation of Energy and Exergy Assessment of Vapor Compression Refrigeration Unit Enhanced via Encapsulated Phase Change Material

Experimental assessment of using phase change materials in vapor compression refrigeration systems for condenser pre-cooling

Performance Evaluation of a Modified Refrigeration Cycle with Parallel Compression for Refrigerator-Freezer Applications

Performance Analysis of a Modified Zeotropic Mixture (R290/R600) Refrigeration Cycle with Internal Subcooler for Freezer Applications

Theoretical investigation on an ejector–expansion refrigeration cycle using zeotropic mixture R290/R600a for applications in domestic refrigerator/freezers

Energy and exergy analysis of zeotropic mixture R290/R600a vapor-compression refrigeration cycle with separation condensation

Dynamic evaluation of a vapor compression refrigeration cycle combined with a PCM storage tank for improving condenser performance

Influence of coupling air conditioner with hybrid PCMs on building interior conditions and consumed power: Experimental investigation

An experimental investigation of vapor compression refrigeration cooling and energy performance for CPU thermal management

Investigation on the Melting Performance of a Phase Change Material Based on a Shell-and-Tube Thermal Energy Storage Unit with a Rectangular Fin Configuration

Energy and economic analysis of a building air-conditioner with a phase change material (PCM)

Evaluation of Phase Change Materials for Pre-Cooling of Supply Air into Air Conditioning Systems in Extremely Hot Climates

Experimental and numerical analysis of a phase change material-based shell-and-tube heat exchanger for cold thermal energy storage

Experimental and Numerical Performance Analysis of an Active Cooling Wall Module Equipped with Micro-encapsulated Phase Change Material

Performance Enhancement Of A Vapor-Compression Cycle With Cold Storage For Freezer Applications

Influence of Different Melting Points of Phase Change Material on Photovoltaic Phase Change Materials System Performance: An Energy, Exergy, and Environmental Point of View

Performance and Thermal Charging/discharging Features of a Phase Change Material Assisted Heat Pump System in Heating Mode

Experimental research on the use of phase change materials in perforated brick rooms for cooling storage

Thermal performance assessment of phase change material for electronic cooling: An experimental investigation

Theoretical Study on a Vapor Compression Refrigeration System with Cold Storage for Freezer Applications

The Effect of Microencapsulated PCM Slurry Coolant on the Efficiency of a Shell and Tube Heat Exchanger