Abstract:Using thermal energy storage such as phase change materials (PCMs) is a suitable solution to reduce energy consumption in order to maintain thermal comfort conditions inside the building. There is a wide range of phase change materials according to their different characteristics such as melting temperature, freezing temperature, latent heat capacity, specific heat value of solid and liquid phase, thermal conductivity coefficient, and charge and discharge range, which makes it difficult to choose the right PCM. In this research, two common groups of phase change materials that are used commercially are studied and after performing a sensitivity analysis on them, a suitable temperature range is selected. Then the selected PCMs are placed in different parts of the external envelopes of the building and various parameters such as air conditioning system energy consumption, thermal comfort, heat balance, etc. are examined. It should be noted that in this study, the use of PCMs in buildings with cooling and heating systems is investigated. In order to carry out the simulation, a two-story office building located in Arak, Iran was modeled in Design Builder software along with all the details. The outputs show that if Bio PCM is used in the outer layer of the wall in the summer season, it is possible to save up to 154 w/m2 in the energy required for cooling the building. While the use of Bio PCM M91 Q21 material in the inner layer of the wall will reduce the load of the cooling system by 246.15 Wh/m2. Also, if RT PCM is used, it is possible to reduce the heat load by 80%. Furthermore, by analyzing the optimal cases, it can be concluded that increasing the thickness of the PCM layer cannot effectively improve the thermal performance of the building. On the contrary, their reduction in some cases leads to a reduction in energy demand in the building. Finally, in order to generalize the results, the optimal situation was compared with two similar climates of Arak city.

Energy reduction of building air-conditioner with phase change material in Thailand

Energy and economic analysis of a building air-conditioner with a phase change material (PCM)

Thermal Performance Curve Analysis for Enhancement of an Air Conditioner in Thailand

Evaluation of Phase Change Materials for Pre-Cooling of Supply Air into Air Conditioning Systems in Extremely Hot Climates

Energy and exergy analysis with cost-efficiency comparison of modified phase change material (PCM) integrated with solar panel thermal system

Influence of coupling air conditioner with hybrid PCMs on building interior conditions and consumed power: Experimental investigation

Integrating phase change material in building envelopes combined with the earth-to-air heat exchanger for indoor thermal environment regulation

Experimental study of the thermal and energy conservation characteristics of combined phase change material (PCM) room in summer

Enhancing thermal comfort in buildings through the integration of phase change material on the building envelope: a simulation study

Experimental Study on the Demand Shifting Effects of PCM Integrated Air-Conditioning Duct

Study on the Influence of the Application of Phase Change Material on Residential Energy Consumption in Cold Regions of China

Experimental assessment of using phase change materials in vapor compression refrigeration systems for condenser pre-cooling

Experimental investigation of PCM transient performance in free cooling of the fresh air of air conditioning systems

A comparative evaluation on energy consumption of a building using bio-based and paraffin-based phase change materials integrated to external building envelope

Experimental Investigation and Numerical Modeling of Room Temperature Control in Buildings by the Implementation of Phase Change Material in the Roof

Derivation of appropriate temperature change for application of phase change materials in building walls for energy reduction in Korean climatic conditions

Experimental research on the use of phase change materials in perforated brick rooms for cooling storage

Energy management of residential buildings using innovative passive techniques

Study on the Optimization of PCM Integrated Air-Conditioning Duct for the Demand Shifting

Power saving in a central air conditioning system by using multiple PCMs integrated with fresh air path

Heat transfer characteristics of coconut oil as phase change material to room cooling application