Abstract:Electrolytic manganese residue (EMR) is a solid waste that contains a significant amount of soluble manganese and ammonia nitrogen, which can pose risks to human health if improperly disposed of. This study aimed to prepare cementitious materials containing abundant ettringite crystals by mixing EMR with various proportions of granulated blast furnace slag (GBFS) and alkaline activators (CaO, Ca(OH) 2 , clinker, NaOH). The resulting cementitious material not only utilized a substantial amount of EMR but also exhibited comparable strength to ordinary Portland cement. The optimal ratios were determined through mechanical testing. Additionally, the leaching toxicity of cementitious materials was assessed using ICP-MS (inductively coupled plasma mass spectrometer) tests. The microscopic properties, hydration, and mechanism of heavy metal solidification in the cementitious materials were evaluated using XRD (X-ray diffraction), SEM (scanning electron microscope), EDS (energy-dispersive spectrometer), FTIR (Fourier transform infrared spectroscopy), and TG (thermogravimetric) techniques. The results showed that the optimal ratio for the cementitious materials was 60% EMR, 36% GBFS, and 4% Ca(OH) 2 . The hardened mortar exhibited compressive strengths of 34.43 MPa, 41.3 MPa, and 50.89 MPa at 3 days, 7 days, and 28 days, respectively, with an EMR utilization rate of 60%. The hydration products of EMR-based cementitious materials were C-(A)-S-H, AFt, and ferromanganese compounds, which contribute to the mechanical strength. The Mn 2+ and NH 4 + -N contents of raw EMR were 1220 and 149 mg/L, respectively. Nonetheless, the leaching of Mn 2+ and NH 4 + -N in the alkali-EMR-GBFS system was significantly below the limits set by the Chinese emission standard GB8978-1996. Within this system, C-(A)-S-H and AFt could physically adsorb and displace heavy metals, Ca 6 Mn 2 (SO 4 ) 2 (SO 3 ) 2 (OH) 12 · 24H 2 O could replace Al ions with Mn ions, and ferromanganese compounds Fe 2 Mn(PO 4 ) 2 (OH) 2 · (H 2 O) 8 and MnFe 2 O 4 could chemically precipitate Mn 2+ .

Mechanical properties and environmental characteristics of the synergistic preparation of cementitious materials using electrolytic manganese residue, steel slag, and blast furnace slag

Study of microscopic properties and heavy metal solidification mechanism of electrolytic manganese residue-based cementitious materials

Preparation of electrolytic manganese residue-ground granulated blastfurnace slag cement

Deep insight into green remediation and hazard-free disposal of electrolytic manganese residue-based cementitious material

Utilization of ground granulated blast-furnace slag and electrolytic manganese residue as a low-carbon cementitious material

Synergistic Preparation of Geopolymer Usining Electrolytic Manganese Residue, Coal Slag and Granulated Blast Furnace Slag

Preparation and Performance Study of Manganese Slag-Based Grouting Cementing Material

Investigation on sulfate activation of electrolytic manganese residue on early activity of blast furnace slag in cement-based cementitious material

Study On Cementing Material Making With Electrolytic Manganese Residue

Feasibility of Low-Carbon Electrolytic Manganese Residue-Based Supplementary Cementitious Materials

Study on the Alkali–Sulfur Co-Activation and Mechanical Properties of Low-Carbon Cementitious Composite Materials Based on Electrolytic Manganese Residue, Carbide Slag, and Granulated Blast-Furnace Slag

Synthesis of Electrolytic Manganese Slag–Solid Waste-Based Geopolymers: Compressive Strength and Mn Immobilization

Solidification/stabilization of electrolytic manganese residue using phosphate resource and low-grade MgO/CaO.

Study on Strength of EMDS-GBFS Composite Cement

Heavy Metals Migration During the Preparation and Hydration of an Eco-Friendly Steel Slag-Based Cementitious Material

Preparation of activated electrolytic manganese residue-slag-cement ternary blended cementitious material: Hydration characteristics and carbon reduction potential

Reuse of hazardous electrolytic manganese residue: Detailed leaching characterization and novel application as a cementitious material

Preparation of Cementitious Material Based on Alkali-GGBS-Manganese Alloy Slag System

Preparation and Mechanical Performance of Supplementary Cementing Materials Cementitious by Electroplating Sludge

Preparation of steel slag-based cementitious materials compounded with GBFS and phosphogypsum: mix design, hydration, and microstructure characteristic

Feasibility of Preparing Steel Slag–Ground Granulated Blast Furnace Slag Cementitious Materials: Synergistic Hydration, Fresh, and Hardened Properties