Probing Ferroelectricity in Pbzr0.2ti0.8o3 with Polarized Soft X Rays
E. Arenholz,G. van der Laan,A. Fraile-Rodriguez,P. Yu,Q. He,R. Ramesh
DOI: https://doi.org/10.1103/physrevb.82.140103
IF: 3.7
2010-01-01
Physical Review B
Abstract:Probing Ferroelectricity in PbZr 0.2 Ti 0.8 O 3 with Polarized Soft X-rays E. Arenholz, 1 G. van der Laan, 2 A. Fraile-Rodr´ iguez, 3 P. Yu, 4 Q. He, 4 and R. Ramesh 4 Advanced Light Source, Lawrence Berkeley National Laboratory, Berkeley, CA 94720 Diamond Light Source, Chilton, Didcot, Oxfordshire OX11 0DE, United Kingdom Swiss Light Source, Paul Scherrer Institut, CH 5232 Villigen, Switzerland Department of Materials Science and Engineering and Department of Physics, University of California, Berkeley, CA 94720, USA (Dated: June 7, 2010) The reduction in symmetry associated with the onset of ferroelectric order in PbZr 0.2 Ti 0.8 O 3 (PZT) thin films leads to a pronounced difference at the Ti L 3,2 absorption edges between spectra measured with the x-ray linear polarization perpendicular and parallel to the ferroelectric polar- ization. We introduce a general method to analyze the observed difference spectra using atomic multiplet calculations. Moreover, we find experimental evidence for structural changes in PZT induced by the reversal of the ferroelectric polarization. PACS numbers: 77.80.-e, 78.70.Dm, 78.20.Bh Ferroelectric oxides exhibit a spontaneous, stable and switchable electric polarization that is due to atomic dis- placements of positive metallic ions and negative oxygen ions in opposite directions, which reduces the symme- try of the crystal lattice.[1] In thin films—especially im- portant for applications such as non-volatile memories [2]—interface and surface effects can dominate over the bulk like behavior of the film interior [3]. For example strain induced by the lattice mismatch between substrate and film lead to enhanced ferroelectric polarization and transition temperature in BaTiO 3 on (110) GdScO 3 and (110) DyScO 3 substrates [4]. Experiments and calcula- tions have shown that ferroelectric surfaces with oppo- site polarity have different characteristics for adsorbing molecules and catalytic activity [5–7]. Conversely, the chemical environment can control the polarization of a ferroelectric film by determining the ionic compensation at its surface [8]. To shed light on the impact of ferroelectric order on the electronic and atomic structure in the surface near region of ferroelectric PbZr 0.2 Ti 0.8 O 3 (PZT) films deposited on SrRuO 3 (SRO) and La 0.7 Sr 0.3 MnO 3 (LSMO) electrodes, we employed soft x ray absorption (XA) spectroscopy. We show that the reduction in symmetry around the Ti 4+ ions has a pronounced impact on the Ti L 3,2 absorption edges which can be explained using atomic multiplet cal- culations. Moreover, we find experimental evidence for changes in the PZT structure induced by the reversal of the ferroelectric polarization. (100)-oriented SrTiO 3 substrates were etched by buffered HF acid and annealed in flowing oxygen at 1000 ◦ C for 3h. Bottom electrodes, 30nm pseudomor- phic layers of SRO and LSMO, were grown by pulsed laser deposition (PLD) at 700 ◦ C with oxygen pres- sure of 100mTorr and 200mTorr, respectively. 70 to 200-nm-thick PZT films were deposited on the elec- trodes at 630 ◦ C in 100mTorr of oxygen. Piezo-force mi- croscopy (PFM) confirmed that the ferroelectric polar- ization in the PZT/SRO points away from the bottom electrode while it points towards the bottom electrode in PZT/LSMO [9]. XA experiments were performed on beamline 4.0.2 at the Advanced Light Source by record- ing the sample drain current as a function of photon en- ergy [10]. Photoemission electron microscopy (PEEM) experiments were carried out on the SIM beamline at the Swiss Light Source [11]. All spectra were acquired at ambient temperature at pressures ≤ 5 · 10 −9 Torr with 100% linearly polarized x-rays impinging at an angle of 16 ◦ to the sample surface probing the topmost 5-8nm. Figure 1(a) shows XA spectra obtained from PZT/SRO. The Ti L 3,2 spectrum exhibits the charac- teristic structure of a Ti 4+ d 0 configuration [12] due to electric-dipole transitions to 2p 5 3d 1 final states. The 2p spin-orbit interaction splits the spectrum into 2p 3/2 (L 3 ) and 2p 1/2 (L 2 ) structures with energy separation of ∼5.5 eV, which are further split by crystal-field interaction, i.e., the electrostatic potential, V , due to the neighboring lattice sites acting on the 3d orbitals. In octahedral (O) site symmetry the e orbitals of Ti point towards the oxy- gen ligands, while the t 2 orbitals point in between them, resulting in a lower energy for the latter. With increas- ing photon energy the four main peaks can therefore be labeled according to their main character as 2p 3/2 3d(t 2 ), 2p 3/2 3d(e), 2p 1/2 3d(t 2 ), and 2p 1/2 3d(e), c.f., Fig. 1. None of these states is pure due to mixing by 2p-3d electro- static interactions. Distortion of the Ti site from octa- hedral symmetry results in a non-symmetric broadening of especially the 3d(e) peaks [13]. Lowering to tetrago- nal symmetry splits the t 2 (O) states into b 2 = d(xy) and e = d(xz, yz) and the e(O) states into b 1 = d(x 2 −y 2 ) and a 1 = d(z 2 ). This gives a difference between XA spectra taken with polarization along the z- and x,y-directions, i.e., parallel and perpendicular to the surface normal. We observe a ±20% difference in the photon energy range of the 2p 3/2 3d(t 2 ) peak [c.f., Fig. 1(a)]. Smaller but still easily detectable intensity differences are found at higher