Abstract:Abstract Previous testing has shown that infrasound sensors deployed in the field can exhibit notable deviations from their nominal, lab-based calibrations. These variations may be due to changes in environmental conditions, long-term sensor drift, or other unresolved features. In early 2018, we installed two identical infrasound elements with five infrasound sensors at each element (Chaparral M50A, Chaparral M64LN, CEA/Martec MB2005, CEA/Seismowave MB3a, and Hyperion IFS-5113A). These sensors were accepted or under consideration for use in the International Monitoring System network of the Comprehensive Nuclear-Test-Ban Treaty. Each element had all sensors connected to a single digitizer and port to the atmosphere. We also recorded instrument enclosure air temperature and humidity and external air temperature. Using the MB2005 as the reference, we examine the relative sensor response (both magnitude and phase) as a function of time and frequency and compare it with quarterly laboratory calibrations and environmental conditions. We find that the magnitude response for all sensors exhibits some variability in both the lab and field, with the amplitude variations often >5%. The field-based variations are more severe and occur on both long-term (months) and short-term (hours) timescales. Short-term variability correlates with changes in environmental conditions and is considerable (up to 25%) for the Chaparral M50A and noticeable (∼5%) for the French Alternative Energies and Atomic Energy Commission (CEA) MB3a. Long-term magnitude variability for the Chaparral M50A was up to 50% and does not clearly correlate with environmental conditions. The other sensors show some long-term magnitude offsets, but they have relatively stable responses in the conditions we examined. The MB3a also displays some frequency-dependent magnitude variability and shows a minor dependence on temperature. Phase estimates are stable and near zero for all sensors tested. These results strongly suggest sensor response and variability due to environmental conditions should be considered in future infrasound data interpretation and sensor selection and development.

Characterization and performance of an acoustic sensor for fission gas release characterization devoted to JHR environment measurements

Design, manufacture and temperature characterization of screen-printed acoustic sensors for monitoring the release of fission gases in experimental fuel rods of the Jules Horowitz reactor

Thermal neutron detection based on resistive gaseous devices

A Mass Sensor with High Sensitivity Based on Thin Film Bulk Acoustic Resonators

Acoustic modeling and performance evaluation of 3D-printed and metal differential photoacoustic sensors for trace gas detection

A high-performance infrared photoacoustic sensor with improved low-frequency response microphone

Characterization of the phonon sensor of the CRYOSEL detector with IR photons

Wireless Passive Sensor Technology through Electrically Conductive Media over an Acoustic Channel

MAGIS-100 Environmental Characterization and Noise Analysis

Highly Sensitive Capacitive MEMS for Photoacoustic Gas Trace Detection

Spectral Characterization of PVDF Sensor Designs for Acoustic Spectroscopy

State-of-the-Art Laser Gas Sensing Technologies

Pressure-Compensated Fiber-Optic Photoacoustic Sensors for Trace SO 2 Analysis in Gas Insulation Equipment

Characterization of Bonded Piezoelectric Sensor Performance and Durability in Simulated Aircraft Environments

Evaluation of Scintillator Detection Materials for Application within Airborne Environmental Radiation Monitoring

Chemically Sensitized Thin-Film Bulk Acoustic Wave Resonators As Humidity Sensors

Development of quantitative detection method for mass spectrometry coupled to an infrared laser spectroscope (Picarro) to monitor in nitrogen matrix a complex gas mixture of H2 , He, CO, N2 , Ne, O2 , Ar, CO2 , H2 S, CH4 , C2 H4 , C2 H6 , C3 H6 , C3 H8 , i-C4 H10 , n-C4 H10 , and C5 H12

Long-Term Infrasound Sensor Calibration and Characterization

Development of interdigital transducer sensors for non-destructive characterization of thin films using high frequency Rayleigh waves

Evaluation of Gas and Particle Sensors for Detecting Spacecraft-Relevant Fire Emissions

Understanding Piezo Based Sensors for Acoustic Neutrino Detection