Abstract:The influence of the mineral composition of water on the results of silicon determination by high-resolution atomic absorption spectrometry with a continuous spectrum source (HR-CS-ETAAS) and electrothermal atomization technique using a contrAA 700 spectrometer has been studied. The study was conducted using samples of natural water from different regions of the Russian Federation and model solutions. A low degree of silicon atomization was recorded when analyzing samples with a complex matrix against the background of a strong absorption signal of matrix components. The reason for the non-selective absorption of the sample matrix by chemical compounds has been demonstrated using a water sample with the most complex composition and a total hardness of about 2000 °dH. The effect of soluble salts of Ca (II) and Mg (II) in the presence of macrocomponents — alkali metal ions K (I) and Na(I) — on the determination of silicon in water has been proved. It is shown that at the values of the total stiffness less than 15 °dH there is no dependence of the analytical signal on the content of matrix components. An assumption is made about the strong influence of calcium compounds on the determination of the analyte due to the formation of a carbide coating on the surface of a graphite furnace, the appearance of a «memory effect» and an increase in the background signal during subsequent atomization cycles. The best results of the silicon determination were obtained with tungsten, iron, magnesium, and palladium present as chemical modifiers. A method of diluting the sample solution was used to reduce the level of background absorption during electrothermal atomization of mineral water. Conditions for eliminating the influence of matrix components for real samples of mineral water and calibration solutions are proposed. A method for determination of the dissolved forms of silicon in water samples with a complex matrix has been developed. The correctness of the results of silicon determination in the samples of natural underground water in the case of a strong matrix effect was confirmed by an independent method of analysis. The results of the study reveal the entirely new prospects of using the method of high-resolution electrothermal atomic absorption spectrometry with a continuous spectrum source for the determination of silicon in natural water.

Determination of Cr and Ni in Seawater by High-Resolution Continuum Source Electrothermal Atomic Absorption Spectrometry

Highly sensitive determination of total chromium in seawater by inductively coupled plasma-mass spectrometry with sample introduction of ultrasound nebulization-dielectric barrier discharge vapor generation

Sensitive analysis of selenium speciation in natural seawater by isotope-dilution and large volume injection using PTV-GC-ICP-MS

Determination of ultra-trace level Cr(VI) in seawater using large-volume direct injection by LC-ICP-MS with in-line matrix elimination

Simultaneous Determination of Cr, As, Se, and Other Trace Metal Elements in Seawater by ICP-MS with Hybrid Simultaneous Preconcentration Combining Iron Hydroxide Coprecipitation and Solid Phase Extraction Using Chelating Resin

Simultaneous Measurements of Cr, Cd, Hg and Pb Species in Ng L-1 Levels by Interfacing High Performance Liquid Chromatography and Inductively Coupled Plasma Mass Spectrometry.

Chemical Speciation of Arsenic and Chromium in Seafood by LC-ICP-MS

Bi-anode Electrochemical Hydride Generation Atomic Fluorescence Spectrometry for the Determination of Arsenic in Seawater

Multielemental Isotopic Analysis for Trace Metals in Geochemical Samples, Part 1: Dissolved Iron, Nickel, Copper, Zinc, Cadmium, and Lead in Seawater

Determination of iron and nickel in water and brine by solvent extraction and atomic absorption spectroscopy

Semi-automatic determination of tin in marine materials by continuous flow hydride generation inductively coupled plasma atomic emission spectrometry

Multielemental Determination of Rare Earth Elements in Seawater by Inductively Coupled Plasma Mass Spectrometry (ICP-MS) After Matrix Separation and Pre-concentration With Crab Shell Particles

Determination of Cobalt in Seawater by Catalytic Adsorptive Cathodic Stripping Voltammetry

Direct Determination of Cadmium, Lead, and Zinc in Mussels by Two-Stage Probe Atomization (TPA) Graphite Furnace Atomic Absorption Spectrometry (GFAAS)

Direct Determination of Nitrite Traces in High Ionic-Strength Samples by Electrostatic Ion Chromatography Using Diluted Acid Solutions As Eluent

Study of the effect of matrix components of natural mineral water on the determination of dissolved forms of silicon by high-resolution electrothermal atomic absorption spectrometry with a continuous spectrum source

Multielement electrochemical vapor generation system coupled with atomic fluorescence spectrometer for simultaneous measurement of trace levels of As and Hg in coastal seawater samples

Systematic Study for Determining As, Pb, Cd, and Se in Steel and Nickel Alloy Samples by GF AAS: Circumventing Matrix Interference with Extraction Based on Micellar Separation

Preconcentration by coprecipitation of arsenic and tin in natural waters with a Ni-pyrrolidine dithiocarbamate complex and their direct determination by solid-sampling atomic-absorption spectrometry

Separation and preconcentration system based on ultrasonic probe-assisted ionic liquid dispersive liquid-liquid microextraction for determination trace amount of chromium(VI) by electrothermal atomic absorption spectrometry

On-site Determination of Pb2 + and Cd2 + in Seawater by Double Stripping Voltammetry with Bismuth-Modified Working Electrodes