Abstract:This graphical abstract presents a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B architecture, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage, an OTA‐based RC integrator with anti‐aliasing properties, is chopped to mitigate offset and 1/f noise, while the second stage employs a switched‐capacitor integrator with OTA‐sharing to reduce complexity and enable signal addition before quantization. Fabricated in a 180‐nm CMOS process, the DSM achieves a 103 dB dynamic range in a 100 Hz bandwidth, with peak SNDR, SNR, and SFDR values of 95.8 dB, 97.1 dB, and 102.8 dB, respectively, and consumes 10.7 μ A from a 1.8 V supply. The Schreier figure‐of‐merit (FoMs) is 170.2 dB, highlighting its energy efficiency. This paper reports a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B topology, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage is an OTA‐based RC integrator with inherent anti‐aliasing properties, while the second stage is a switched‐capacitor integrator. Offset and 1/f noise in the first stage are mitigated by the chopper‐stabilization technique, while those in the second stage are suppressed through the gain provided by the first stage. Furthermore, the OTA‐sharing technology is utilized in the second stage to realize signal addition before quantization, reducing design complexity. The hybrid DSM prototype is fabricated with a 180‐nm CMOS process and occupies an area of 0.123 mm2. Measurement results show peak SNDR/SNR/SFDR values of 95.8, 97.1, and 102.8 dB, respectively, with a current consumption of 10.7 μ A from a 1.8‐V single supply. The reported DSM achieves a 103‐dB dynamic range in a 100‐Hz signal bandwidth, corresponding to a Schreier figure‐of‐merit (FoMs) value of 170.2 dB.

Design and implementation of a fully differential 2nd‐order CIFF DSM with the synthetic techniques of novel CDS chopper‐integrator and DER using additive‐error capacitors

An 18-Bit 2-2 MASH Delta-Sigma Modulator for Isolated Amplifier

A 10.7-Μa 103-Db DR Hybrid Delta-Sigma Modulator for Sensing Applications

A 153μw 26nv/√hz Readout Circuit with BW and Power Scalability Using Capacitively-Coupled Chopper Floating Inverter Amplifier Embedded in a Discrete-Time ΔΣ Modulator

A Fully Dynamic 4-Channel 13b Simultaneous Sampling Incremental ΔΣ ADC Using Cascoded Floating-Inverter-Amplifier and Code Division Multiplexing Technique

A 200 KHz Bandwidth ΣΔ DAC with a Spur Free Modulator

A 200 Khz Bandwidth Ea Dac With A Spur Free Modulator

Modeling of a 200 KHz Bandwidth Low-pass Switch-capacitor Sigma-delta DAC with a Raised Spur-free Modulator

A 96 dB DR Second-Order CIFF Delta-Sigma Modulator with Rail-to-Rail Input Voltage Range

A Partially Feedback NSSAR Embedded Third-Order Delta–Sigma Modulator with Gain-Boosted Two-Stage FIAs

A 74.5-dB Dynamic Range 10-MHz BW CT-ΔΣ ADC With Distributed-Input VCO and Embedded Capacitive- π Network in 40-nm CMOS

A 0.37mm 2 250kHz-BW 95dB-SNDR CTDSM with Low-Cost 2 nd -order Vector-Quantizer DEM.

A 0.37mm<sup>2</sup> 250kHz-BW 95dB-SNDR CTDSM with Low-Cost 2<sup>nd</sup>-order Vector-Quantizer DEM

A 10.7‐μ A 103‐dB DR Hybrid Delta‐Sigma Modulator for Sensing Applications

A 10-Khz BW 104.3-Db DR Discrete-Time Delta-Sigma Modulator with Ring-Amplifier-based Integrator

An OTA-Less Second-Order VCO-Based CT $\delta\sigma$ Modulator Using an Inherent Passive Integrator and Capacitive Feedback

100.5 dB SNDR Analog Front-End With a Resistor-Based Discrete-Time Delta-Sigma Modulator for Eliminating Switching Noise and Harmonics

A 16-Bit 4.0-Gs/s Calibration-Free 65 Nm DAC Achieving >70 Dbc SFDR and < −80 Dbc IM3 Up to 1 GHz with Enhanced Constant-Switching-Activity Data-Weighted-Averaging

A Digital Front-End of 16-Bit Audio Delta-Sigma DAC with Improved CSE Method and Novel DWA

An 88 dB SNDR 100 kHz BW Sturdy MASH Delta-Sigma Modulator Using Self-Cascoded Floating Inverter Amplifiers

An 18.2W 101.1dB DR Fully-Dynamic ADC with Partially-Feedback Noise- Shaping Quantizer and CLS-Embedded Two-Stage FIAs