Abstract:This graphical abstract presents a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B architecture, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage, an OTA‐based RC integrator with anti‐aliasing properties, is chopped to mitigate offset and 1/f noise, while the second stage employs a switched‐capacitor integrator with OTA‐sharing to reduce complexity and enable signal addition before quantization. Fabricated in a 180‐nm CMOS process, the DSM achieves a 103 dB dynamic range in a 100 Hz bandwidth, with peak SNDR, SNR, and SFDR values of 95.8 dB, 97.1 dB, and 102.8 dB, respectively, and consumes 10.7 μ A from a 1.8 V supply. The Schreier figure‐of‐merit (FoMs) is 170.2 dB, highlighting its energy efficiency. This paper reports a low‐power, high dynamic range second‐order delta‐sigma modulator (DSM) for sensing applications. The DSM employs a hybrid CIFF‐B topology, consisting of a continuous‐time first stage and a discrete‐time second stage. The first stage is an OTA‐based RC integrator with inherent anti‐aliasing properties, while the second stage is a switched‐capacitor integrator. Offset and 1/f noise in the first stage are mitigated by the chopper‐stabilization technique, while those in the second stage are suppressed through the gain provided by the first stage. Furthermore, the OTA‐sharing technology is utilized in the second stage to realize signal addition before quantization, reducing design complexity. The hybrid DSM prototype is fabricated with a 180‐nm CMOS process and occupies an area of 0.123 mm2. Measurement results show peak SNDR/SNR/SFDR values of 95.8, 97.1, and 102.8 dB, respectively, with a current consumption of 10.7 μ A from a 1.8‐V single supply. The reported DSM achieves a 103‐dB dynamic range in a 100‐Hz signal bandwidth, corresponding to a Schreier figure‐of‐merit (FoMs) value of 170.2 dB.

An 18-Bit 2-2 MASH Delta-Sigma Modulator for Isolated Amplifier

A 0.18 μm Single-poly CMOS ∑-△ Modulator for Digital Audio Applications

An Audio Cascaded Sigma Delta Modulator Using Gain-Boost Class-C Inverter

A 10.7-Μa 103-Db DR Hybrid Delta-Sigma Modulator for Sensing Applications

The Design of a High-Accuracy Sigma-Delta Modulator with 2-2 Mash Structure

A Σδ Modulator Using Gain-Boost Class-C Inverter for Audio Applications.

An audio cascaded ΣΔ modulator using gain-boost class-C inverter

A High-Performance,Low-Power ΣΔ Modulator for Digital Audio Applications

A 65-Nm Low-Noise Low-Costς△modulator for Audio Applications

Low-power High-Linearity Sigma-Delta Modulator for Audio Applications

Behavioral Modeling of Third- order Cascaded Sigma - delta Modulators

An 88 dB SNDR 100 kHz BW Sturdy MASH Delta-Sigma Modulator Using Self-Cascoded Floating Inverter Amplifiers

A 0.8-V 230-$\mu$ W 98-dB DR Inverter-Based $\Sigma \Delta$ Modulator for Audio Applications.

A 22-Bit 34-uW Sturdy-MASH Digital Delta-Sigma Modulator with Nested Bus-Splitting and Resolution Enhancement

A 10.7‐μ A 103‐dB DR Hybrid Delta‐Sigma Modulator for Sensing Applications

A 1v 663 Mu W 15-Bit Audio Delta Sigma Modulator In 0.18 Mu M Cmos

A Low Power Audio Delta-Sigma Modulator with Opamp-Shared and Opamp-Switched Techniques

0.9 V 58 Μw 92 Db SNDR Audio ΔΣ Modulator with High Efficiency Low Noise Switched-Opamp and Novel DWA Technique

A 9-Mw Continuous-Time Hybrid Active-Passive Sigma Delta Modulator With 84-Db Dynamic Range

A Partially Feedback NSSAR Embedded Third-Order Delta–Sigma Modulator with Gain-Boosted Two-Stage FIAs

Self-coupled MASH Delta-Sigma Modulator with Zero Optimization