Abstract:As tellurides and selenides of Bismuth are extensively used thermoelectric materials in the low-temperature range with refrigeration application, A concerted effort is put forth to boost the ZT by co-doping the pristine Bi 2 Se 3 with antimony (Sb) on cation end and tellurium (Te) on anion side of the compound. The double sintered solid-state reaction method is employed in the preparation of Bi 2 Se 3 and (Bi 1− x Sb x ) 2 Se 2.7 Te 0.3 polycrystalline pellets, with x = 0.02, 0.04, and 0.06. The sample exhibits a rhombohedral structure with the space group of R m. FESEM and EDAX analysis are used to confirm surface morphology and elemental composition of the produced samples. The thermoelectric measurements for the pristine and co-doped samples were conducted by the physical property measurement system as well as a considerable increase in the Seebeck coefficient of − 115 μV/K is observed for 0.02 doping of the Sb which is 4.2 times greater than as for pristine (S = − 28 μV/K). Higher concentration doping ( x = 0.04, 0.06) has not reflected any Seebeck coefficient advancement. In contrast, the lowest total thermal conductivity at a low-temperature regime (< 50 K) is observed for x = 0.06 doping concentration which at near room temperature increases beyond the pristine thermal conductivity; whereas, x = 0.02, 0.04 doping concentration shows a decrement in total thermal conductivity at low, at room temperature region the values are almost equivalent to that of pristine. The co-doped samples' electrical resistivity is substantially less than pristine sample. The highest power factor of 3 × 10 –4 μW/mK 2 is obtained for the x = 0.02 sample. The highest ZT value for the x = 0.02 sample is almost 28 times more than a pristine sample. We conducted a study where we combined experimental and DFT methods to investigate thermoelectric properties incorporated into pristine and doped with antimony and tellurium on Bi 2 Se 3 . We have employed this combination to investigate the partial density of states, Seebeck coefficient, power factor using the Boltzmann transport equation. Theoretical thermoelectric data were derived and compared to experimental observations. Hence, using combined experimental and theoretical investigations helps to predict with higher accuracy of thermoelectric properties of semiconducting materials.

Dysprosium-Doping Influence on the Microstructure and Texturing of Bismuth-Telluride Thermoelectric Materials

EFFECT OF DYSPROSIUM DOPING ON MICROSTRUCTURE AND DEGREE OF TEXTURING OF BISMUTH TELLURIDE-BASED THERMOELECTRIC MATERIALS

Microstructure and thermoelectric properties of porous Bi 2 Te 2.85 Se 0.15 bulk materials fabricated by semisolid powder processing

Synthesis, structure and anisotropy of thermoelectric properties of Bi-=SUB=-2-=/SUB=-Te-=SUB=-2.7-=/SUB=-Se-=SUB=-0.3-=/SUB=- compound doped with samarium

Dysprosium doping induced effects on structural, dielectric, energy storage density, and electro-caloric response of lead-free ferroelectric barium titanate ceramics

On the Synthesis, Microstructure, and Thermoelectric Properties of the Composite Material Bi2Te2.7Se0.3/Teδ Obtained from Asymmetric Nanoparticles

Influence of Grain Structure Features on the Thermoelectric Properties of Compounds Based on Bismuth Telluride

A comprehensive experimental and DFT analysis on thermoelectric properties of Sb, Te co-doped Bi2Se3 polycrystals

Microscopic effects of Dy-doping in the topological insulator Bi2Te3

High-temperature thermoelectric properties of (1-x)DyBCO − xBNT ceramics

EFFECT OF FEATURES IN GRAIN STRUCTURE ON THE THERMOELECTRIC PROPERTIES OF COMPOUNDS BASED ON BISMUTH TELLURIDE

Rare Earth Element Doping Introduces Pores to Improve Thermoelectric Properties of p-Type Bi 0.46 Sb 1.54 Te 3

Doping Effect on Thermoelectric Properties of Nonstoichiometric AgSbTe 2 Compounds

Enhanced Dielectric properties of Bismuth Doped Barium Titanate Ceramics with their Structural and Compositional Studies

Influence of Ag2te Doping on the Thermoelectric Properties of P-Type Bi0.5sb1.5te3 Bulk Alloys

Atomic-scale Chemical Mapping of Copper Dopants in Bi2Te2.7Se0.3 Thermoelectric Alloy

Electronic Transport and Thermoelectric Properties of Te-Doped Tetrahedrites Cu12Sb4-yTeyS13

Doping Effect on the Dielectric Property in Bismuth Titanate

Effect of Doped Aluminium into Bismuth Telluride on the Structural and Optical Properties by Thermal Evaporation

Effect of Doping and Annealing on Thermoelectric Properties of Bismuth Telluride Thin Films

Enhancing the Thermoelectric and Mechanical Properties of Bi 0.5 Sb 1.5 Te 3 Modulated by the Texture and Dense Dislocation Networks