Abstract:7075-T6 aluminum alloy is widely used in the manufacture of various structural parts of aircraft, most of which are joined and assembled through hole structures. However, stress concentration will occur around the hole during the service process of the part, which is easy to cause fatigue failure. It is significant to improve the fatigue performance of the hole structure. In this work, surface strengthening of 7075-T6 aluminum alloy holes induced by split sleeve cold expansion (SCE) was studied regarding surface microstructure, microhardness, and residual stress profiles. The effects of SCE process on the fatigue properties in different stress levels were finally discussed. The results show that the surface of the SCE sample undergoes severe plastic deformation and forms a gradient grain structure with a layer of nanocrystals in the outermost layer. This process lead to an increase of surface microhardness by about 14.3% and a compressive residual stress of up to 255 MPa. Dislocation slip is dominant deformation mechanism in the expansion process. During expansion, more dislocation tangles, dislocation walls and dislocation cells appear, which induces the formation of sub-grain boundaries and refines the grains. In the SCE samples, the high-strength nanocrystals on the surface of holes, the excellent resistance to strain localization of the gradient structure and the high compressive residual stress can effectively hinder the initiation of fatigue cracks and increase the high-cycle fatigue life by 9 times.

Fatigue performance on 7050 aluminum alloy by twice hole expansion strengthening of split mandrel

Effect of Initial Overload on the Low Cycle Fatigue Life of Gh4169 Alloy at Different Temperatures

Fatigue performance on 7050 aluminum alloy by using ultrasonic vibration-assisted hole expansion strengthening

Revealing the Interrelation Between Process Parameters and Microstructure to Promote the Mechanical Performance for Hastelloy-X

Investigation on fatigue failure of split-sleeve cold expansion holes of 7075-T651 aluminum alloy

Effect of split sleeve cold expansion on microstructure and fatigue performance of 7075-T6 aluminum alloy holes

Effect of split-sleeve cold hole expansion on the fatigue performance of an additive manufactured TC18 alloy

Influence of Multi-Holes on Fatigue Behaviors of Cast Magnesium Alloys Based on In-Situ Scanning Electron Microscope Technology

Cold Expansion Strengthening of 7050 Aluminum Alloy Hole: Structure, Residual Stress, and Fatigue Life

Finite Element Analysis of Split Sleeve Cold Expansion Process on Multiple Hole Aluminum Alloy

Study on the Residual Stress Distribution of Bi-Directional Cold Expansion Process Performed on Open Holes

Numerical investigation on the effects of circuit parameters on the plastic deformation of fastener holes in thin aluminum alloy via electromagnetic expansion process

Improving the fatigue performance of AZ31 sheet with hole via electromagnetic cold expansion process

Numerical investigation of the effect of hole reaming on fatigue life by cold expansion

Investigation on fatigue performance and microstructure of split sleeve cold expansion of TC4 holes

Effects of Hole Cold Expansion on Fatigue Behaviors of AlSi10Mg Plate Manufactured by Selective Laser Melting

Defect-related strain-controlled high-temperature fatigue behavior in additive manufacturing Hastelloy X assisted with ultrasonic micro-forging treatment

Improvement in fatigue performance of thin fasteners via electromagnetic strengthening process

Experimental Study on the Effect of Reaming on the Fatigue Life of Split-Sleeve Cold-Expanded Ti-6Al-4V Alloy Components

Effect of cold expansion on the fatigue life of multi-hole 7075-T6 aluminum alloy structures under the pre-corrosion condition

Cold Hole Expansion Process for Stress Analysis and Evaluation of Fatigue Properties