Abstract:This work used piperazine (PZ) as a base solvent, blended individually with five amines, which were monoethanolamine (MEA), secondary amines (DIPAs), tertiary amines (TEAs), stereo amines (AMPs), and diethylenetriamine (DETA), to prepare mixed solvents at the desired concentrations as the test solvents. A continuous bubble-column scrubber with one stage (1 s) was first used for the test. Six parameters were selected, including the type of mixed solvent (A), the ratio of mixed solvents (B), the solvent feed rate (C), the gas flow rate (D), the concentration of the mixed solvents (E), and the liquid temperature (F), each one having five levels. Using the Taguchi experimental design, only 25 runs were required. The outcome data, such as the absorption efficiency (EF), the absorption rate (RA), the overall mass-transfer coefficient (KGa), and the absorption factor (φ), could be determined under steady-state conditions. The optimal mixed solvents were found to be A1 (PZ + MEA) and A2 (PZ + DIPA). The parameter importance and optimal conditions for EF, RA, KGa, and φ were determined separately; the verification of all optimal conditions was successful. This analysis found that the importance of the parameters was D > C > A > E > B > F, and the gas flow rate (D) was the most important factor. Subsequently, multiple-stage scrubbers were used to capture CO2. Comparing 1 s and 3 s (three-stage scrubber), EF, RA, KGa, and φ increased by 33%, 29%, 22%, and 38%, respectively. The desorption tests for the four optimal scrubbed solutions, including multiple stages, showed that the heat of regeneration for the three scrubbers was 3.57–8.93 GJ/t, in the temperature range of 110–130 °C, while A2 was the best solvent. Finally, the heat regeneration mechanism was also discussed in this work.

Carbon Dioxide Capturing via a Randomly Packed Bed Scrubber Using Primary and Poly Amine Absorbents

Reducing Aerosol and Ammonia Emission in Post-Combustion CO2 Capture: Additives As Key Solutions

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Experimental Study On Efficient Absorption Of Carbon Dioxide From Simulation Flue Gas By Rotary Packed Bed

CO2 Adsorption on Pore-Engineered Carbons Derived from Jute Sticks

Numerical Study on a Structured Packed Adsorption Bed for Indoor Direct Air Capture

Cost-effective carbon-based amine adsorbents for carbon capture: Equilibrium, kinetics and selectivity

Experimental Studies on Removal of Carbon Dioxide by Aqueous Ammonia Fine Spray

Performance study on mixed solvent for post‐combustion carbon capture using rotating packed bed technology

Removal of carbon dioxide with adsorption-desorption cycling of an activated carbon bed: Effects of bed geometry and cycle parameters

The amine-functionalized alumina captures CO 2 directly from the ambient air in the Rotating Adsorption Bed

Carbon Capture From Coal Power Plants And Algae Farming With Technical-Economic Analysis

CFD Analysis of CO2 Sequestration Applying Different Absorbents Inside the Microporous PVDF Hollow Fiber Membrane Contactor

Experimental study on the effect of process parameters on postcombustion CO2 capture using rotating packed bed technology

Carbon Dioxide Recovery From Flue Gases By Ammonia Scrubbing

Design and optimization of a packed bed scrubber for purification of waste gas containing ammonium

Piperazine-Based Mixed Solvents for CO2 Capture in Bubble-Column Scrubbers and Regeneration Heat

Comparison of several packings for CO2 chemical absorption in a packed column

Emerging Solvent Regeneration Technologies for CO2 Capture through Offshore Natural Gas Purification Processes

Mixed Amine Absorbent based on Hollow Fiber Membrane Contactor Removes CO2 from Flue Gas

The Effect of the Packing Flow Area and Biogas Flow Rate on Biogas Purification in Packed Bed Scrubber