Comparison of several packings for CO2 chemical absorption in a packed column

Xinglei Zhao,Kathryn H. Smith,Michael A. Simioni,Wendy Tao,Sandra Elizabeth Kentish,Weiyang Fei,Geoffrey Wayne Stevens
DOI: https://doi.org/10.1016/j.ijggc.2011.07.006
IF: 4.4
2011-01-01
International Journal of Greenhouse Gas Control
Abstract:CO2 capture and storage has gained widespread attention as an option for reducing greenhouse gas emissions. Chemical absorption and stripping of CO2 with hot potassium carbonate (K2CO3) solutions has been used in the past, however potassium carbonate solutions have a low CO2 absorption efficiency. Various techniques can be used to improve the absorption efficiency of this system with one option being the addition of promoters to the solvent and another option being an improvement in the mass transfer efficiency of the equipment. This study has focused on improving the efficiency of the packed column by replacing traditional packings with newer types of packing which have been shown to have enhanced mass transfer performance. Three different packings (Super Mini Rings (SMRs), Pall Rings and Mellapak) have been studied under atmospheric conditions in a laboratory scale column for CO2 absorption using a 30wt% K2CO3 solution. It was found that SMR packing resulted in a mass transfer coefficient approximately 20% and 30% higher than that of Mellapak and Pall Rings, respectively. Therefore, the height of packed column with SMR packing would be substantially lower than with Pall Rings or Mellapak. Meanwhile, the pressure drop using SMR was comparable to other packings while the gas flooding velocity was higher when the liquid load was above 25kgm-2s-1. Correlations for predicting flooding gas velocities and pressure drop were fitted to the experimental data, allowing the relevant parameters to be estimated for use in later design. © 2011.
What problem does this paper attempt to address?