Abstract:Distribution characteristics of the current, ampere force and magnetic flux density (B [T]) of a novel high temperature superconducting (HTS) cable woven by transposed REBCO tapes under different transposition lengths are proposed, and these characteristics of the cable stacked with 3 REBCO tapes are also carried out in this paper for comparison. The objective is to enhance the current density and the compactness of the HTS tapes combination, and uniform the current, ampere force and magnetic flux density (B [T]) distributions. A 3D finite element model (FEM), based on Maxwell's equations without consideration of the displacement current, is established to describe the state of the system in the liquid nitrogen condition. The distributions characteristics, maximum and minimum values of current, ampere force and magnetic flux density (B [T]) show significant differences in the simulation results between the novel HTS cable woven by 3 transposed REBCO tapes and the cable stacked with 3 REBCO tapes. The simulated results show that the distribution characteristics are improved, with a more uniform distribution characteristic than that of the cable stacked with REBCO tapes. This is due to fully transposed REBCO tapes. In addition, the experimental E-I curve was also reached. The experimental results show that using a shorter transposition length in the cable can improve the critical current. However, A too small transposition length can cause significant damage to the HTS tape, resulting in deformation of the HTS tape and a reduction in the electromagnetic properties of the HTS tape. This affects the critical current of the HTS tape and, ultimately, the critical current of the cable. From the point of view of whether the production process is convenient, meets the requirements of economy and reduces costs, we need to find a suitable transposition length. The measured optimal transposition length is 95 mm for the cable woven by 3 REBCO tapes. Ethical Compliance: All procedures performed in studies involving human participants were in accordance with the ethical standards of the institutional and/or national research committee and with the 1964 Helsinki Declaration and its later amendments or comparable ethical standards.

A Test of HTS Power Cable in a Sweeping Magnetic Field

Development of a Conduction-Cooled HTS SMES

Analytical Formulae for Hysteresis Power Loss in Twisted Stacked HTS Cables

An Experimental Investigation of Critical Current and Current Distribution Behavior of Parallel Placed HTS Tapes

Characteristics of Aluminium-stabilized HTS Detector Magnet Cable at 4 K and 5 T

Design Study on a 100-Ka/20-k HTS Cable for Fusion Magnets

Measurement and Analysis of the Dynamic Effects in an HTS Dipole Magnet

Optimization methods for HTS DC and AC cables with longitudinal magnetic field effect

AC losses in HTS sector shaped high-current conductors for fusion coils

Design and Testing of a Prototype Canted-Cosine-Theta HTS Dipole Magnet Using CORC Cable

Structural Design and Mechanical Analysis of HTS CICC Made From Twisted Stack Slotted-Core Cable

A review of commercial high temperature superconducting materials for large magnets: from wires and tapes to cables and conductors

Critical current characteristics and ampere force distribution of a novel HTS cable with different transposition lengths

HTS Cable and Protection System Study for UK's 275 kV Transmission Network

Transient Analysis of HVDC HTS Cable in Power Grid Using Discretized Electrical-Thermal Model

Design and Test of HTS Power Converting System with Multiple Magnets Considering Various Sequential Controls of Heater-Triggered Switches

Comparative study of current carrying capacity between 1G and 2G HTS tape samples at different temperatures and magnetic fields

A New HTS Cable Project in Japan

Research Status of High Temperature Superconducting Power Cable

Determination of I-V Curves of HTS Tapes From The Frequency Dependent AC Transport Loss

Analysis of Current Distributions in HTS Tapes of Superconducting Bipolar DC Energy Pipeline