Abstract:Due to the 2050 Net Zero Emissions becoming a major goal worldwide, electric vehicles have emerged as the future mainstream products. Among them, copper foils play a crucial role as the anode current collector in lithium-ion batteries (LIBs). Enhancing the strength and decreasing the thickness of copper foil are both important factors improving the lifespan of LIBs. The thickness of Cu foils can be reduced by rolling copper sheets, but it is challenging to achieve the required thinness below 10 micron for electronic applications. Direct current electroplating not only effectively increases the deposition rate but also reduces costs for thin Cu foils. In this study, we utilized a rotary direct current Cu-Ni co-electroplating method to enhance the mechanical strength of nanotwinned copper. The ultimate tensile strength (UTS) of nanotwinned copper-nickel alloy reached over 847.3 MPa (an increase of approximately 12.6 % compared to the maximum UTS of nanotwinned copper, which was 752.8 MPa) while maintaining excellent electrical conductivity similar to nanotwinned copper. Through potentiostat analysis, it was discovered that nickel ions inhibit copper growth, causing the reduction potential of copper to shift negatively, resulting in a decreased deposition rate and increased twin density. The nickel content, measured by ICP-MS, was found to be 0.467 ppm, suggesting that nickel acts as an impurity that refines grain size in copper foils. Therefore, this method not only significantly improves the strength of copper foils but also maintains low electrical resistance and low-cost characteristics. It provides a new material option for the anode current collector of the next-generation LIBs. Figure 1

High-strength copper foil prepared with 2-mercaptothiazoline by direct current electrodeposition

Preparation of electrodeposited copper foils with ultrahigh tensile strength and elongation: A functionalized ionic liquid as the unique additive

Trace Bis-(3-sulfopropyl)-disulfide Enhanced Electrodeposited Copper Foils

A novel strategy to electrodeposit high-quality copper foils using composite additive and pulse superimposed on direct current

Enhancing Surface Roughness and Tensile Strength of Electrodeposited Copper Foils by Composite Additives

Preparation, micro-structure and characterization of high strength and low profile lithium copper foil with SPS and HP additives

High Strength and High Ductility Copper Obtained by Topologically Controlled Planar Heterogeneous Structures

Functional additives inhibit crystal growth to achieve low-roughness and high-peel strength of micro-coarsening copper foil

Rotary Electrodeposition of High-Strength Nanotwinned Copper Foils

Mechanical Properties and Microstructure of Rolled and Electrodeposited Thin Copper Foil

Preparation of Ultra-thin sandwich Cu-Cu/CNTs-Cu Composite Foil with High Tensile Strength by Electrodeposition

High-efficiency and low-consumption preparation of ultra-thin and high-performance nanotwinned copper foils by high-gravity intensified direct current electrodeposition

Effect of additives on the microstructure and properties of pulsed electrodeposited copper foils

Preparation of Ultra-thin Copper Foil with Low Profile and High Tensile Strength on Surface of 18-μm Carrier Copper Foil

Effect of additives on microstructure and properties of the coarsened layer of very low profile (HVLP) copper foil

Microcrystalline copper foil as a high performance collector for lithium-ion batteries

Improvement of performance stability of electrolytic copper foils by bi-component additives

Electroless Deposition of Automatically Shedded Thin Copper Foils

Microstructure-controlled Electrodeposition of Mechanically Reliable Double-layered Thin Foils for Secondary Batteries

Combining Solid Solution Strengthening and Second Phase Strengthening for Thinning Li Metal Foils