Abstract:The single pole-to-ground (SPG) fault is one of critical failures which will have a serious impact on the stable operation of the multi-terminal DC distribution network based on the modular multilevel converter (MMC). It is very significant to analyze fault characteristics for detecting faults and protection design. This paper established the DC SPG fault model, which showed that in the presence of a reactor, the short-circuit current was reduced from 2.3 kA to 1 kA at 6 ms after the fault. Then, a novel SPG fault protection strategy was proposed, which detected the current derivative in connection transformer grounding branch. When the value increases past the threshold of current derivative, small resistance was switched on to increase fault current. Thus, the reliability of differential protection was enhanced. Compared with the traditional protection method, the proposed method does not need communication, and improved the speed of protection. Finally, the simulation model was established in PSCAD/EMTDC. The model included three converter stations: T1, T2 and T3. Among them, T1 outputs power, and T2 and T3 receive power. The results of RTDS showed that the DC circuit breaker operated within 3 ms, the three-port circuit breaker worked within 50 ms, which proves that the proposed strategy was effective. At this time, the system switched from the T1–T2–T3 three-terminal networking operation mode to the T1–T2 two-terminal hand-in-hand operation mode. Since the T3 terminal no longer received power, the transmission power of the T1 terminal decreased, and the received power of the T2 terminal remained unchanged.

Novel Fault Protection Method for Flexible DC Power Systems

A Single-Ended Protection for Multi-terminal Flexible DC Distribution System

Fault protection scheme of flexible DC grid based on transient power instantaneous energy difference

Flexible DC System Fault Analysis

Simplified Method for Fault Transient Analysis of Flexible DC Distribution Lines

A Novel Topology of DC Distribution Network with Fault Current Limiting Static Synchronous Series Compensator

Single-ended DC line protection scheme based on first peak time of current-limiting reactor voltage

Time-Domain Fault Detection and Location Scheme for Flexible DC Distribution Networks

A Fault Diagnosis Method for Solid-state Fault Current Limiters Used in Three Phase Ungrounded System

A Modified DC Fault Protection Scheme for Multi-Terminal HVDC Grid Based on Fault Current Limiters

Fault detection method for flexible DC grid based on current limiting reactance voltage variability

Hybrid Multi-Infeed Receiver Line Longitudinal Protection Scheme Based on Voltage Waveform Comprehensive Distance Similarity

Transient Current Correlation Based Protection for DC Distribution System

Protection and Fault Isolation Scheme for DC Distribution Network Based on Active Current-Limiting Control

Optimization Of Current Breaker And Fault Current Limiter In Dc Micro-Grid Based On Faulty Transient Analysis

Research on Protection Coordination Between Flexible DC System and Breaker

A Novel Protection Strategy for Single Pole-to-Ground Fault in Multi-Terminal DC Distribution Network

Fault Characteristic Analysis and a Novel Pilot Protection Scheme for Pole-to-Ground Fault in Flexible DC Distribution Network

Frequency Domain Impedance Based Protection for Flexible DC Distribution Grid

A Convolution Power-Based Protection Scheme for Hybrid Multiterminal HVDC Transmission Systems

Protection Algorithm for Fault Identification and Isolation in DC Microgrid