Abstract:Catalytic ozonation is an efficient method for VOCs abatement at low temperatures, in which the rational design of highly active heterogeneous catalysts constitutes the most significant step. In this study, Al2O3 was first optimized by loading MnOx. And then K was used for modifying MnOx/Al2O3 catalyst, which exhibited 2.4 x 10(-3) mol.g(-1).s(-1) oxidation rate for dichloromethane and toluene oxidation with ca. 0.89 ppm ozone detected at 80 degrees C. That could be directly applied for removing toluene and dichloromethane mixture or coupled with other treatment technologies (such as biological purification). Besides, appropriate K doping could increase the amount of reactive surface oxygen species and the ratio of Mn2+, hence contributing to an enhanced oxidation ability. By contrast, an excess K doping inevitably lowered the activity of active surface oxygen species and interfered with the transformation of Mn3+ to Mn2+, which resulted in a weakened oxidative ability and thus a decreased cat-alytic activity. Finally, the reaction mechanisms over 0.1 K-MnOx/Al2O3 were tried to be demonstrated that the degradation of toluene mainly followed the pathway of toluene - phenylcarbinol - benzaldehyde - benzoic acid - phenyl group - small-molecule species and/or CO2 while the route of dichloromethane - methanol - formal-dehyde - formic acid - small-molecule species and/or CO2 explained the catalytic oxidation of dichloromethane. All of these findings may facilitate the design of novel heterogeneous catalysts for VOCs oxidation and progress the development of catalytic ozonation for toluene and dichloromethane abatement.

Catalytic wet oxidation of o-chlorophenol at mild temperatures under alkaline conditions

Catalytic Ozonation of Multiple Vocs at Low Temperature over a Potassium-Modified Mnox-Based Catalyst

The Co-Activation of Persulfate with Tannic Acid and Sodium Hydroxide for the Degradation of p-Chlorophenol

Highly Catalytic Performance for the Selective C-H Bond Oxidation of P-Chlorotoluene over Co, Cr Co-Doped OMS-2 Catalyst

Catalytic Wet Air Oxidation of Ochlorophenol in Wastewater

Degradation Of 4-Chlorophenol By Catalytic Ozonation Using Gamma-Al2o3/Tio2 Supported Managanese Oxides In Aqueous Solution

Fe Salts As Catalyst for the Wet Oxidation of O-Chlorophenol

Catalytic Wet Air Oxidation of Phenol with Ru/ZrO2-CeO2 Catalyst

Catalytic wet air oxidation of phenol over RuO2/gamma-Al2O3 catalyst

Preparation of RuO2/γ-Al2O3 Catalysts and Study on Catalytic Wet Air Oxidation of Phenol

Effect of Calcination Temperature on the Catalytic Activity of Nanosized TiO2 for Ozonation of Trace 4-Chloronitrobenzene

Oxidation Products And Degradation Pathways Of 4-Chlorophenol By Catalytic Ozonation With Mnox/Gamma-Al2o3/Tio2 As Catalyst In Aqueous Solution

Oxidation Products and Degradation Pathways of 4-Chlorophenol by Catalytic Ozonation with MnOx/γ-Al2O3/TiO2 As Catalyst in Aqueous Solution

Catalytic Ozonation of Toluene and Dichloromethane Mixture at Low Temperatures over Modified MnOx-based Catalyst

MnO2/TiO2-Catalyzed ozonolysis: enhancing Pentachlorophenol degradation and understanding intermediates

Efficient Treatment of Phenol Wastewater by Catalytic Ozonation over Micron-Sized Hollow MgO Rods

OXIDATION FOR REMOVAL OF TOTAL ORGANIC CARBON (TOC) FROM HIGH STRENGTH PHENOLIC WASTEWATER IN SUPERCRITICAL WATER

Treatment of phenol wastewater by microwave-induced ClO2-CuOx/Al203 catalytic oxidation process.

Removal of 2,6-Dichlorophenol in Water by CuO Activated Peroxymonosulfate: Efficiency, Mechanism and Degradation Pathway

Photocatalytic ozonation of 2, 4-dichlorophenoxyacetic acid in water with a new TiO2 fiber

Catalytic wet oxidation of phenol in a trickle bed reactor over a Pt/TiO2 catalyst