Abstract:Volatile organic compounds (VOCs) are both harmful to human health and the environment; however, catalytic combustion offers a promising method for VOC purification because of its high efficiency without secondary pollution. Although manganese-based catalysts have been well studied for VOC catalytic oxidation, their catalytic activity at low temperature must be improved. Alkali metals as promoters have the potential to modulate the electronic and structural properties of the catalysts, improving their catalytic activity. Herein, a Ce0.65Zr0.35O2 support was prepared by co-precipitation and MnOx/Ce0.65Zr0.35O2 catalysts were obtained through the incipient-wetness impregnation method. The catalytic properties of K-modified MnOx/Ce0.65Zr0.35O2 for toluene oxidation with different molar ratios of K/Mn were investigated. In addition, the catalysts were characterized by XRD, UV/visible Raman, Hydrogen temperature program reduction (H-2-TPR), Oxygen temperature programmed desorption (O-2-TPD), X-ray photoelectron spectroscopy (XPS) and in situ diffuse reflectance FTIR spectroscopy (DRIFTS) experiments. The results showed that alkali metal doping with K significantly improved the catalytic activity. In particular, when the molar ratio of K/Mn was 0.2, the monolith catalyst Mn/Ce0.65Zr0.35O2-K-0.2 exhibited the best performance with the lowest complete conversion temperature T-90 of 242 degrees C at a GHSV of 12000 h(-1). The XRD results suggested that MnOx was uniformly distributed on the surface of the catalyst and that Mn4+ partially reduced to Mn3+ on the addition of K. The Raman spectrum demonstrated that with increasing K content, both the beta- and alpha-MnO2 phases coexisted on the Mn/Ce0.65Zr0.35O2-K-0.2 catalyst, increasing the number of surface defect sites. The H-2-TPR experiment results confirmed that Mn/Ce0.65Zr0.35O2-K-0.2 exhibited the lowest reduction temperature and good reducibility. From the O-2-TPD experiments, it was clear that Mn/Ce0.65Zr0.35O2-K-0.2 contained the most surface adsorbed oxygen species and excellent lattice oxygen mobility, which benefitted the toluene oxidation activity. In addition, the XPS results suggested that the content of surface adsorbed oxygen species of the Mn/Ce0.65Zr0.35O2-K-0.2 catalyst was the highest among all the tested samples. In addition, toluene-TPSR in N-2 as measured by in situ DRIFTs analysis demonstrated that available lattice oxygen was present in the Mn/Ce0.65Zr0.35O2-K-0.2 catalyst. Therefore, the Mn/Ce0.65Zr0.35O2-K-0.2 catalyst exhibited the best redox properties and oxygen mobility of the prepared samples and showed excellent activity toward toluene oxidation. Therefore, it was concluded that the addition of an appropriate amount of K improved the redox performance of the catalyst and increased the number of surface defect sites and mobility of the lattice oxygen of the catalyst as well as the concentration of the surface active oxygen species, thereby significantly improving catalytic ability.

Catalytic Ozonation of Toluene and Dichloromethane Mixture at Low Temperatures over Modified MnOx-based Catalyst

Catalytic Ozonation of Multiple Vocs at Low Temperature over a Potassium-Modified Mnox-Based Catalyst

Catalytic Ozonation of Toluene over Amorphous Cu-Mn Bimetallic Oxide: Influencing Factors, Degradation Mechanism and Pathways.

Catalytic Ozonation of Formaldehyde with an Oxygen-Vacancy-Rich MnOx/γ-Al2O3 Catalyst at Room Temperature

Catalytic Ozonation of Toluene over Spinel Cumn2o4: Influencing Factors, Reaction Mechanism and Pathways

Adsorption and Catalytic Ozonation of Toluene on Mn/ZSM-5 at Low Temperature

Boosting Ozone Catalytic Oxidation of Toluene at Room Temperature by Using Hydroxyl-Mediated MnOx/Al2O3 Catalysts.

Boosting Ozone Catalytic Oxidation of Toluene at Room Temperature by Using Hydroxyl-Mediated MnO<sub><i>x</i></sub>/Al<sub>2</sub>O<sub>3</sub> Catalysts

Pt/MnOx for Toluene Mineralization Via Ozonation Catalysis at Low Temperature: SMSI Optimization of Surface Oxygen Species

Low Temperature Catalytic Ozonation of Toluene in Flue Gas over Mn-based Catalysts: Effect of Support Property and SO2/water Vapor Addition

Enhanced Catalytic Ozonation of Toluene Using Supported MnOx/USY Via Regulating the Distribution of Aluminum Species in USY by Dealumination

Catalytic ozonation of dichloromethane at low temperature and even room temperature on Mn-loaded catalysts

Room Temperature Catalytic Ozonation of Toluene over Mno2/Al2o3

Tuning the Micro-coordination Environment of Al in Dealumination Y Zeolite to Enhance Electron Transfer at the Cu-Mn Oxides Interface for Highly Efficient Catalytic Ozonation of Toluene at Low Temperatures

Catalytic Oxidation of Toluene Over Potassium Modified Mn/Ce0.65Zr0.35O2 Catalyst

Catalytic oxidation of VOCs over Mn/TiO2/activated carbon under 185 nm VUV irradiation

Experimental Study on Catalytic Oxidation of Toluene with Manganese Catalysts and Ozone at Low Temperature

Catalytic Oxidation of Toluene Over Potassium Modified Mn/Ce<sub>0.65</sub>Zr<sub>0.35</sub>O<sub>2</sub> Catalyst

Promoting the Catalytic Ozonation of Toluene by Introducing SO42– into the Α-Mno2/zsm-5 Catalyst to Tune Both Oxygen Vacancies and Acid Sites

MnOx/Al2O3 Catalyzed Ozonation for Low-Concentration BTX Removal at Room Temperature

Tuning the properties of oxygen vacancy around Cu-Mn mixed oxides on dealumination Y zeolite by P-doping to achieve ultra-efficient catalytic ozonation of toluene with low ozone consumption