Abstract:This paper focuses on the time-variant radio frequency interference (RFI) issue that ultra-wide band (UWB) through-wall radar (TWR) is faced with, and presents an iterative dual sparse recovery (IDSR) framework to combat it. The framework consists of two stages: 1) RFI estimation and detection and 2) IDSR of scattered echoes from objects and RFI signals. In the first stage, an overlapped short time Fourier transform is employed to construct and update the discrete frequency Doppler spectrum (DFDS). Then, a minimum statistic operation is conducted on the DFDS to estimate RFI signals, followed by detection via a 1-D cell-averaging constant false alarm rate detector to determinate whether RFI signals exist or not. In the second stage, a dual sparse model of the collected signals is set up, based on the fast-time frequency sparsity of RFI signals because of their narrow bands and the Doppler frequency sparsity of scattered echoes from objects because of their limited moving velocities. The alternating direction method of multipliers (ADMM) is introduced to iteratively and alternately recover RFI signals and scattered echoes from objects. Specifically, the iterative hard thresholding (IHT) method is used to complete the two sparse recovery operations. The involved two sparse dictionaries are simple and only made up of inverse discrete Fourier transform basis and independent of the received signals. The IDSR framework is able to relieve the influences of RFI signals and scattered echoes from objects on each other, and thus can reconstruct the two type signals to the maximum limit. Field experiments using a UWB TWR were carried out to verify the proposed method.

Millimeter-Wave Receiver With Non-Uniform Time-Approximation Filter

A 0.5-8Ghz Reconfigurable CMOS RF Receiver Front-end for CR and DPA Applications

A Sub-1-GHz Band High-Dynamic-Range Receiver with Integrated Self-Adaptive Multipart AGC Loops

An 800-Ps Origami True-Time-Delay-Based CMOS Receiver Front End for 6.5–9-Ghz Phased Arrays

Estimation and Mitigation of Time-Variant RFI Based on Iterative Dual Sparse Recovery in Ultra-Wide Band Through-Wall Radar.

A Time-Approximation Filter for Direct RF Transmitter

A non-coherent receiving solution for near field pulse UWB communication

A 0.4-6 GHz Blocker-Tolerant Receiver in 65 Nm CMOS with Bandwidth-Extended Technologies for Future V2X Applications

IIP2-Calibration-Free Receiver Front End With Notch-Filtered Low-Noise Transconductance Amplifier for 5G New Radio Cellular Applications

Analog Front-End RX Design for UWB Impulse Radio in 90nm CMOS.

A 253- $\mu $ W 2.4-Ghz SAW-Less Mixer-First Uncertain-IF Receiver with Blocker Tolerant for Long-Distance Ultralow-Power IoT

A K/Ka/V Triband Single-Signal-Path Receiver With Variable-Gain Low-Noise Amplifier and Constant-Gain Phase Shifter in 28-nm CMOS

SAW-Less Direct RF Transmitter With Multimode Noise Shaping and Tri-Level Time-Approximation Filter

A Low-Power, Compact, 0.1–5.5-Ghz, 40-Dbm IB OIP3 LNTA-First Receiver for SDR

5.4 A 22.4-to-30.7ghz Phased-Array Receiver with Beam-Pattern Null-Steering and Beam-Tracking Techniques Achieving >30.2db OTA-Tested Spatial Rejection

Fully Integrated 24-GHz 1TX-2RX Transceiver for Compact FMCW Radar Applications

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

A 164-$\mu$ W 915-MHz Sub-Sampling Phase-Tracking Zero-IF Receiver With 5-Mb/s Data Rate for Short-Range Applications

A 140-Ghz FMCW TX/RX-Antenna-Sharing Transceiver with Low-Inherent-Loss Duplexing and Adaptive Self-Interference Cancellation

An Ultra-Low-Voltage 2.4-GHz Flicker-Noise-Free RF Receiver Front End Based on Switched-Capacitor Hybrid TIA With 4.5-dB NF and 11.5-dBm OIP3

A Chip Solution for UWB-NFC Receiver in CMOS 0.18um Technology