Abstract:A frequency-modulated ultrawideband (FM-UWB) hybrid transceiver, with a high system reuse ratio up to 90%, is fabricated in the 65-nm CMOS process for both short-range wireless communication and high-resolution radar ranging. The radio frequency (RF) front-ends (RFFEs) based on module stacking and current reuse achieve significant RF power savings of about 30% and 50% for the transmitter and the receiver (RX), respectively. The presented IF zero-crossing delay discrimination benefits a high radar resolution less than 1 cm. A multimode relaxation oscillator (OSC) for the reconfigured triangular subcarrier generation and a dual-path ring voltage-controlled oscillator (VCO) for the linear FM, stacked by a wideband push–pull power amplifier (PA), generate an FCC-compliant UWB signal. An active balun embedded low-noise amplifier (LNA) and two symmetric-detuning band-passed filters (BPFs) are stacked with the bandwidth extension to linearly demodulate the UWB FM signal. Experimental results show that the 3.75–4.25-GHz hybrid transceiver has an energy efficiency of 1.9 nJ/bit with an active area of 0.7 mm2 and a power dissipation of 1.9 mW and achieves the RX sensitivity of −71 dBm and the transmitted power of −14.1 dBm, with a bit error rate (BER) of 10−4 at a distance of 4 m under the data rate (DR) of 0.1–1.0 Mbps. The transceiver also achieves the noise figure (NF) of 4.8 dB and the phase noise of −78.6 dBc/Hz at 1-MHz offset frequency.

Analog Front-End RX Design for UWB Impulse Radio in 90nm CMOS.

A Low-Power and Flexible Energy Detection IR-UWB Receiver for RFID and Wireless Sensor Networks

CMOS UWB IR Non-Coherent Receiver for RF-ID Applications

A 0.5–15 GHz Reconfigurable IR-UWB Receiver in 28 Nm CMOS

A 90nm-CMOS, 500Mbps, fully-integrated IR-UWB transceiver using pulse injection-locking for receiver phase synchronization

A 90nm CMOS UHF/UWB Asymmetric Transceiver for RFID Readers

A Flexible Energy Detection IR-UWB Receiver for RFID and WSN

A 90‐ to 115‐ghz Superheterodyne Receiver Front‐end for W‐band Imaging System in 28‐nm Complementary Metal‐oxide‐semiconductor

A Digital Back-End of Energy Detection UWB Impulse Radio Receiver

System and chip design for high-speed impulse radio UWB

A high efficiency robust IR-UWB receiver design for high data rate CM-range communications

Low-Power Low-Complexity FM-UWB Hybrid Transceiver for Communication and Ranging

A Reconfigurable FM-UWB Transceiver for Short-Range Wireless Communications

All-digital Sub-sampling Architecture for an Impulse Radio Ultra Wideband Receiver

0.15-Nj/b 3–5-Ghz IR-UWB System with Spectrum Tunable Transmitter and Merged-Correlator Noncoherent Receiver

Cmos Low-Power Analogue Baseband Circuits for a Non-Coherent Low Data Rate IR-UWB Receiver

A Flexible Back-End with Optimum Threshold Estimation for OOK Based Energy Detection IR-UWB Receivers

A non-coherent receiving solution for near field pulse UWB communication

A 6-7 GHz, 40 Db Receiver RF Front-End with 4.5 Db Minimum Noise Figure in 0.13μm CMOS for IR-UWB Applications

Impulse UWB Energy Detection Receiver with Energy Offset Synchronization Scheme

A 0.13&#x03bc;m CMOS UWB Receiver Front-End Using Passive Mixer