Abstract:It is well known from laboratory testing that the rock failure process becomes unstable in a soft test machine due to excessive energy released from the machine. Great efforts had been devoted to increasing the loading system stiffness (LSS) of laboratory test machines to ensure that the post-peak stress–strain curve of rock can be obtained for underground rock engineering design. A comprehensive literature review on the development of stiff test machines reveals that because of the differences in the manufacturing arrangement of the test machines, LSS values of the test machines used for rock property testing are always finite and vary in a large range, and the influence of LSS on stable rock failure is less understood. A FEM-based numerical experiment is carried out to study the influence of LSS on the stress–strain curves of stable rock failure in uniaxial compression, with a focus on the post-peak deformation stage. Three test machine loadings including idealized rigid loading, platen loading, and frame–platen loading with finite LSS are considered, and the simulation results are analyzed and compared. The modeling results obtained from the simulations indicate that even if the LSS value is large enough to inhibit unstable rock failure, as long as LSS is finite, it has an influence on the post-peak stress–strain curve of rock. It is revealed that because the input energy supplied by the external energy source to drive the stable rock failure process is affected by the finite LSS of a test machine, the post-peak descending slopes of the stress–strain curves are all steeper than the post-peak descending slope obtained under an ideal loading condition of infinite LSS. An insight from this numerical experiment is that it might be more feasible to develop laboratory test machines with variable LSS that can match the local mine stiffness in the field for rock property testing.

Variation of Poisson's ratio of hard rocks during compression and an innovative determination method based on axial loading–unloading test

An experimental study of size effect of roughness coefficient on rock joint using push-pull apparatus

A Method for Estimating the Mechanical Parameters of the Laminae of Laminated Rocks Based On Uniaxial Compression and Tensile Tests

Test Research on Negative Poisson's Ratio of Rock Mass

Method of equivalent core diameter of actual fracture section for the determination of point load strength index of rocks

Investigation of Rock Material under Combined Compression and Shear Dynamic Loading: an Experimental Technique

Optimal Loading Rate Design Method for Cement Stone Mechanical Test

Experimental Study on Shear Behavior of Rock Composite Material under Normal Unloading Conditions

STUDY ON STRAIN RATE EFFECT OF SOFT ROCK

Experimental Study on Rock Strength and Deformation Characteristics Under Triaxial Cyclic Loading and Unloading Conditions

Combined effect of pore water pressure and axial stress level on the unloading mechanical properties of sandstone

TESTING STUDY ON COMPRESSIVE MODULUS OF LOOSE ROCK BLOCKS UNDER CONFINING CONSTRAINT

A Correction Methodology to Determine the Real Strain-rate Effect for Rock-like Materials Based on SHPB Testing

Effect of Unloading Rate on the Mechanical Behavior and Fracture Characteristics of Sandstones Under Complex Triaxial Stress Conditions

Effect of loading rates on mechanical behavior and strain localization characteristics of sandstone

A Universal Direct Tensile Testing Method for Measuring the Tensile Strength of Rocks

Experimental assessment on the dynamic mechanical response of rocks under cyclic coupled compression-shear loading

Deformation and mechanical properties of rock: effect of hydromechanical coupling under unloading conditions

Variation of Elastic Stiffness Parameters of Granitic Rock during Loading in Uniaxial Compressive Test

Influence of Loading System Stiffness on Post-peak Stress–Strain Curve of Stable Rock Failures

A New Explanation of loading Rate Effect on Rock Compressive Strength