Abstract:In the current study, a series of laboratory triaxial loading and unloading experiments were conducted for the purpose of comprehensively understanding the effects on sandstone of loading processes under axial stress conditions and unloading processes under confining pressure conditions. The mechanical properties and crack propagation behaviors of sandstone specimens were analyzed. In addition, a new damage variable based on crack evolution was proposed. The experimental results showed that the strain-softening modulus of the sandstone specimens under triaxial loading and unloading compression conditions decreased with the increases in the loading rate. Meanwhile, the elastic modulus was only observed to undergo small changes. This study found that with the increases in the loading rates of axial stress, the deformation and strength levels of the sandstone specimens also increased. In addition, the crack initiation stress showed a linear increasing trend with the increases in the loading rates of axial stress. The peak crack volumetric strain displayed a slight increase with the loading rate of axial stress, which indicated that the larger the loading rate of axial stress on the sandstone specimens was, the smaller crack propagation strain levels at the peak stress levels would be. The crack propagation velocities were observed to be larger when the loading rates of axial stress were higher. Also, at the same loading rate of axial stress, the crack propagation velocity corresponding to the peak stress of the volumetric cracks was the largest, followed by radial cracks. The crack propagation velocity of the axial cracks was determined to be the smallest. In this study, a new crack damage variable based on crack volumetric strain was proposed. According to the evolution of the crack damage variables of the sandstone specimens, the following four stages of the failure process were obtained: original damage stage; elastic stage; linear damage stage; and accelerated damage stage. The results obtained in this research study provided an important scientific basis for the support of future designs and safety protection measures in underground mining operations.

Combined effect of pore water pressure and axial stress level on the unloading mechanical properties of sandstone

Experimental study on mechanical behavior and permeability evolution of weakly cemented sandstone under unloading conditions

Effect of Unloading Rate on the Mechanical Behavior and Fracture Characteristics of Sandstones Under Complex Triaxial Stress Conditions

Effect of Triaxial Loading and Unloading on Crack Propagation and Damage Behaviors of Sandstone: An Experimental Study

Strength and energy exchange of deep sandstone under high hydraulic conditions

Study on dynamic characteristics of sandstone-damaged by loading and unloading

Nonlinear Mechanical and 3D Rupture Morphology of Saturated Porous Sandstone Under True Triaxial Stress

Study on the mechanical properties of unloading damaged sandstone under cyclic loading and unloading

Mechanical Properties and Acoustic Emission Characteristics of Unloading Instability of Sandstone under High Stress

Dilatancy behaviour and permeability evolution of sandstone subjected to initial confining pressures and unloading rates

Effects of dry-wet cycles on the mechanical properties of sandstone with unloading-induced damage

Deformation and mechanical properties of rock: effect of hydromechanical coupling under unloading conditions

Experimental investigation on the stress-dependent permeability of post-failure sandstone under loading–unloading conditions

Experimental Study on the Response of Cracked Sandstone to the Intermediate Principal Stress Coupled with Pore Pressure

Effects of Water and Cyclic Loading on Ultrasonic and Mechanical Properties of Sandstone: An Experimental Study

Influence of moisture content and intermediate principal stress on cracking behavior of sandstone subjected to true triaxial unloading conditions

Experimental and numerical investigations on the mechanical behavior of sandstone subjected to gas undrained triaxial compression

Effects of seepage pressure on the mechanical behaviors and microstructure of sandstone

Effect of loading rates on mechanical behavior and strain localization characteristics of sandstone

Influence of volume compression on the unloading deformation behavior of red sandstone under damage-controlled cyclic triaxial loading

Experimental investigation on the damage and deterioration of sandstone subjected to cycling pore water pressure