Quantification of losses in bent waveguides within DBR-RW laser diodes emitting at 785 nm
Lara Sophie Theurer,Jan-Philipp Koester,André Müller,Martin Maiwald,Andrea Knigge,Bernd Sumpf,Günther Tränkle
DOI: https://doi.org/10.1088/1361-6641/ad26a6
IF: 2.048
2024-02-08
Semiconductor Science and Technology
Abstract:An experimental study of straight and bent distributed Bragg reflector (DBR) ridge waveguide (RW) lasers and Fabry-Pérot RW lasers emitting at 785 nm is presented. To determine the losses introduced by the bent waveguides within DBR-RW lasers, different laser designs were manufactured and characterized. The bent waveguides investigated here within DBR-RW laser diodes are sine-shaped S-bends. S-bends with three different lateral offsets are manufactured. The experimental characterization of Fabry-Pérot lasers and the straight DBR-RW lasers with different coatings at the rear facet enables a rough estimation of the losses caused by the DBR grating and the determination of the DBR reflectivity. Furthermore, additional losses in the bent DBR-RW lasers caused by the S-bend (i.e. radiation and scattering losses) are quantified by comparing them to the straight DBR-RW lasers. Within the active resonator, the S-bend losses amount to αBend = 0.6 cm-1 (αBend = 0.5 dB) for the smallest manufactured lateral S-bend offset H = 40 μm. For both straight and bent DBR-RW lasers spectrally narrow single-mode emission is obtained. A lateral beam width of 3.8 μm (using second moments) and a lateral far-field angle of about 18° and 19.5° (using second moments) for the straight and S-bend DBR-RW are measured, respectively. This gives a lateral beam propagation ratio of 1.2 and 1.3 (using second moments) for straight and S-bend DBR-RW, respectively. The radiation loss in dependency of the lateral S-bend offset is simulated and compared to experimentally estimated S-bend losses for bent DBR-RW lasers (H = 40 μm, H = 60 μm and H = 70 μm).
engineering, electrical & electronic,materials science, multidisciplinary,physics, condensed matter