Nanoscale Pumping Effect of Perovskite via Supported Bilayer Electron Transport Layer for Efficient Printable Mesoscopic Solar Cells

Tian Ding,Wenjun Wu

DOI: https://doi.org/10.1002/ente.202301243

IF: 4.149

2024-02-06

Energy Technology

Abstract:Recent advancements in printable mesoscopic perovskite solar cells (p‐MPSCs) face challenges in improving perovskite precursor solution diffusion during assembly. The research achieves effective gap‐driven diffusion, forming well‐filled perovskite through TiO2 nanorod arrays. The bilayer electron transport layer with dual crystal phase and cascaded energy levels demonstrates superior electron collection and directional transport. Suppression of nonradiative recombination and efficient charge transfer lead to notable enhancements in open‐circuit voltage and short‐circuit current density. Consequently, p‐MPSCs' power conversion efficiency increases from 14.32% to 16.07%, close to literature's highest reported value of 16.21%. These results highlight a novel interface engineering approach for high‐performance p‐MPSCs fabrication. Recently, enhancing the photovoltaic performance of printable mesoscopic perovskite solar cells (p‐MPSCs) poses a significant challenge, particularly in improving the diffusion of perovskite precursor solutions during device assembly. In this research, effective gap‐driven diffusion of the precursor solution perovskite is successfully achieved, leading to the formation of well‐filled and crystallized perovskite through TiO2 nanorod arrays. By incorporating upper‐layer TiO2 nanoparticles, a bilayer electron transport layer with dual crystal phase is developed, establishing a cascaded energy level structure that exhibits superior capabilities in electron collection and directional transport. The effective suppression of nonradiative recombination and efficient charge transfer result in notable enhancements in both open‐circuit voltage and short‐circuit current density. Consequently, the power conversion efficiency of p‐MPSCs devices based on MAPbI3 γ‐butyrolactone solution increases from 14.32% to 16.07% (highest reported value in the literature is 16.21%). These findings highlight a novel interface engineering approach for the fabrication of high‐performance p‐MPSCs devices.

energy & fuels