Abstract:Both crystalline and amorphous MoO2 exhibit distinct advantages for lithium-ion battery applications, with the former favoring lithium-ion intercalation and the latter undergoing complete lithiation via a conversion reaction. However, their sluggish lithium-ion insertion rates and inadequate charge transfer kinetics hinder their full potential. To address these challenges, we have developed a controllable approach that integrates liquid-phase dispersion of the HxMoO3/C and graphene oxides (GO) precursors followed by freeze-drying and low-temperature calcinations, aiming to merit the ionic conductivity of MoO2/C nanocrystallite and the electronic conductivity of reduce graphene oxides (rGO), respectively. This facile method yields bubble-sheet-like MoO2/C@rGO composites, where the quantitatively strategic incorporation of rGO can effectively mitigate recrystallization and surface oxidation of MoO2 nanocrystals. Furthermore, the approximately 70% volume shrinkage of HxMoO3/C precursors into MoO2/C can create a flexible void space between the microspheres and the rGO coating for better accommodating volume variations during lithiation. Electrochemical measurements show that MoO2/C@rGO delivers high initial coulombic efficiency (ICE, e.g., up to 71.3% at 100mAg⁻¹), impressive rate performance (e.g., achieving 60 mAh g⁻¹ at 1Ag⁻¹, and 34.1% retention from 0.1 to 2Ag⁻¹) and excellent cyclability (e.g., retaining 98.9% of its capacity after 200 cycles) when employed as an intercalation-type anode material above 1.00V (vs. Li/Li⁺). Remarkably, electrochemical analysis indicates that the capacitive contribution is dominant during high-rate applications (e.g., up to 73.06% ratio at a scan rate of 0.50mVs⁻¹), exhibiting a pseudocapacitive behavior. Additionally, MoO2/C@rGO exhibits enhanced ICE (e.g., up to 76.9% at 100mAg⁻¹), accelerated activation (e.g., achieving peak performance within 10 cycles at 100mAg⁻¹), superior rate performance (e.g., achieving 446 mAh g⁻¹ at 2Ag⁻¹), and remarkable cyclability (e.g., maintaining 510 mAh g⁻¹ with 88.9% capacity retention over 600 cycles at 1Ag⁻¹) when applied as a conversion-type anode material at between 1.00 to 3.00V (vs. Li/Li⁺). To elucidate the mechanisms underlying the high-rate performance and the increased capacity, ex-situ XRD, ex-situ SEM, ex-situ TEM, and electrochemical analysis were carried out. No evident phase transition or material pulverization can be observed upon cycling above 1.00V; therefore, the structural evolution is entirely single-phase or solid-solution, which accompanies with pseudocapacitive characteristic. However, the diffraction peaks downshift, the eminent of LixMoO2+δ, the pulverization, and the gradual amorphization of MoO2 can be observed upon cycling, indicating an sequential intercalation-to-conversion activation from a crystalline state to an amorphous state.

Insights into self-induced electrochemical activation of carbon cathode

Capacity Enhancement of Porous Carbon Electrodes during Long-Term Cycling in Lithium-Ion Batteries

Surface Modification Effect and Electrochemical Performance of LiOH-High Surface Activated Carbon as a Cathode Material in EDLC

Pre‐activation and Defects Introduced Via Citric Acid to Mitigate Capacity and Voltage Fading in Li‐rich Cathode

Investigating the increased-capacity mechanism of porous carbon materials in lithium-ion batteries

Preparation of Biomass-Derived Carbon Loaded with MnO2 As Lithium-Ion Battery Anode for Improving Its Reversible Capacity and Cycling Performance

Electrochemical Activation Inducing Rocksalt‐to‐Spinel Transformation for Prolonged Service Life of LiMn2O4 Cathodes

Activated carbon/reduced graphene oxide wrapped LiFePO 4 cathode for Li-ion batteries with ultrahigh capacities and high specific energy density

Enhanced Lithium-Ion Storage Through Anchoring Nanocrystalline MoO2/C Microspheres in Rgo Nanosheets: Boosting Pseudocapacitance and Facilitating Rapid Conversion

Self-activation of Cellulose: A New Preparation Methodology for Activated Carbon Electrodes in Electrochemical Capacitors

An Electrochemical-Cycling-Induced Capacitive Component on the Surface of an Electrophoretic-Deposited Lithium Iron Phosphate Cathode

On the Origin of Capacity Increase in Rechargeable Magnesium Batteries with Manganese Oxide Cathodes and Copper Metal Current Collectors

Precious potential regulation of carbon cathode enabling high-performance lithium-ion capacitors

Revealing dual capacitive mechanism of carbon cathode toward ultrafast quasi-solid-state lithium ion capacitors

Self‐Activation Enables Cationic and Anionic Co‐Storage in Organic Frameworks

Electrochemical coverage of reduced graphene oxide layers on sulfur supported by biochar for enhancing performance of Li-S battery

Energy band modulation of Li2O-rGO core-shell as cathode sacrificial additive enables capacity enhancement of hard carbon anode in Li-ion batteries

Revisiting the origin of cycling enhanced capacity of Fe3O4 based nanostructured electrode for lithium ion batteries

Electrochemical conversion from hydroxyl to carbonyl groups for improved performance of dual-carbon lithium ion capacitors

Understanding and Control of Activation Process of Lithium-Rich Cathode Materials

Recent progress in the carbon-based frameworks for high specific capacity anodes/cathode in lithium/sodium ion batteries