Abstract:In this study we synthesized LiFePO4/carbon/reduced graphene oxide (LFP/C/rGO) composite cathode materials using a method involving sol–gel processing, spray-drying, and calcination. To improve the electrochemical performance of LFP/C, we tested graphene oxides (GOs) of various morphologies as conductive additives, including pristine GO, three-dimensional GO, and hydrothermal porous GO (HTGO). Among our samples, the cathode material prepared through spray-drying with the addition of 1 wt% of HTGO (denoted SP-LFP/C/1%rHTGO) displayed the best electrochemical performance; its discharge capacities at 0.1C, 1C, 5C, and 10C were 160.5, 151.8, 138.8, and 130.3 mA h g−1, respectively. From measurements of its long-term cycling performance, the discharge capacity in the first cycle and the capacity retention after 30 cycles at 0.1C were 160.2 mA h g−1 and 99.6%, respectively; at 10C, these values were 132.2 mA h g−1 and 91.8%, respectively. The electronic conductivity of SP-LFP/C/1%rHTGO (6.58 × 10−5 S cm−1) was higher than that of the pristine LFP/C (9.24 × 10−6 S cm−1). The Li+ ion diffusivities (DLi+) of the SP-LFP/C/1%HTGO cathode, measured using AC impedance (3.91 × 10−13 cm2 s−1) and cyclic voltammetry (6.66 × 10−10 cm2 s−1 for discharge), were superior to those of the LFP/C cathode (9.31 × 10−15 cm2 s−1 and 1.79 × 10−10 cm2 s−1 for discharge, respectively). Galvanostatic intermittent titration revealed that the value of DLi+ was located in a reasonable range from 1 × 10−10 to 1 × 10−17 cm2 s−1; its value dropped to its lowest point when the state of charge was close to 50%. Thus, the use of spray-drying and the addition of conductive HTGO (having a 3D wrinkled morphology and interconnected pore structure) can enhance the electronic conductivity and Li+ ion diffusivity of LFP/C cathode materials, thereby improving the electrochemical performance significantly.

Activated carbon/reduced graphene oxide wrapped LiFePO 4 cathode for Li-ion batteries with ultrahigh capacities and high specific energy density

Reduced Graphene Oxide Coating LiFePO4 Composite Cathodes for Advanced Lithium-Ion Battery Applications

Facile preparation of cellulose nanofiber derived carbon and reduced graphene oxide co-supported LiFePO4 nanocomposite as enhanced cathode material for lithium-ion battery

Three-Dimensional Carbon-Coated LiFePO4 Cathode with Improved Li-Ion Battery Performance

Nitrogen-doped Carbon Stabilized LiFe0.5Mn0.5PO4/rGO Cathode Materials for High-Power Li-ion Batteries

Energy band modulation of Li2O-rGO core-shell as cathode sacrificial additive enables capacity enhancement of hard carbon anode in Li-ion batteries

Modifying the morphology and structure of graphene oxide provides high-performance LiFePO4/C/rGO composite cathode materials

A carbon-free LiFePO4 cathode material of high-rate capability prepared by a mechanical activation method

Catalytic Strategies Enabled Rapid Formation of Homogeneous and Mechanically Robust Inorganic‐Rich Cathode Electrolyte Interface for High‐Rate and High‐Stability Lithium‐Ion Batteries

Ultrathin LiFePO4 Nanosheets Self-Assembled with Reduced Graphene Oxide Applied in High Rate Lithium Ion Batteries for Energy Storage

Improving the electrochemical properties of lithium iron(II) phosphate through surface modification with manganese ion(II) and reduced graphene oxide

Ultrafast Fabrication of LiFePO 4 with High Capacity and Superior Rate Cycling Performance for Lithium Ion Batteries

Synthesis of Hierarchical and Bridging Carbon-Coated LiMn0.9Fe0.1PO4 Nanostructure As Cathode Material with Improved Performance for Lithium Ion Battery

Enabling high-performance lithium iron phosphate cathodes through an interconnected carbon network for practical and high-energy lithium-ion batteries

Reduced Graphene Oxide Modified Li2FeSiO4/C Composite with Enhanced Electrochemical Performance As Cathode Material for Lithium Ion Batteries

Cathode‐Electrolyte Interphase Engineering toward Fast‐Charging LiFePO4 Cathodes by Flash Carbon Coating

Chemically Bonding NiFe-LDH Nanosheets on Rgo for Superior Lithium-Ion Capacitors

In-situ and Selectively Laser Reduced Graphene Oxide Sheets As Excellent Conductive Additive for High Rate Capability LiFePO4 Lithium Ion Batteries

In Situ Low-Temperature Carbonization Capping of LiFePO4 with Coke for Enhanced Lithium Battery Performance

Study of LiFePO4 Cathode Modified by Graphene Sheets for High-Performance Lithium Ion Batteries

Porous Co3O4 nanofibers surface-modified by reduced graphene oxide as a durable, high-rate anode for lithium ion battery