Abstract:For reading and writing tasks, poor lighting quality can cause veiling reflections. Veiling reflections are luminous reflections from specular or semi-matte surfaces that physically change the contrast of the visual task and therefore change the stimulus presented to the visual system. Veiling reflections occur at positions where the geometry between the observer, the surface and the light source is such that the angle of incidence equals the angle of reflections and the reflection is in the direction from the surface to the eye of the observer. Nowadays desktop luminaires are commonly used for paper reading and writing, especially for school students. However, because of the positioning of desktop luminaires, they have a high risk of veiling reflection, especially when the reading materials are glossy ones.Some special designs are needed to reduce the veiling reflections, and both traditional optical design elements such as frosted glass and advanced polarization technology are considered to work to some extent. Moreover, with the same light distribution, people's perception of glare may also differed with spectra, so light sources with different Correlated Color Temperature (CCT) were included in the study. This article focused on the desktop luminaires to investigate: (1) the effects of optical design elements (frosted glass, polarized films) on reduction of veiling reflections; (2) Correlation between CCT of light sources and people's perception of veiling reflection.In the experiments, light sources (compact fluorescent lamps) with two CCT levels (3000K, 5000K), and different optical designs (frosted glass, polarized film A, polarized film B) were used, and the average illuminance levels were controlled at the same level. As physical parameters, Contrast Rendering Factor (CRF) and Polarization Percentage were measured. Usually for a lighting installation, there is always a distribution of CRF values, but since for the desktop luminaires, it is the viewing angle of users that mostly matters, the CRF value in this direction was measured. As subjective evaluation, subjects were asked to rate their perception of glare on a under different conditions. A total of 10 Subjects, aged from 20 to 25 years old, participated in the experiments. A deBoer rating scale for glare was used for subjects' evaluation.Through the experiment, a better solution for reduction of veiling reflection of desktop luminaires was proposed, which can benefit the design of desktop luminaires for users' well-being.

Experiment to Evaluate Visibility with Street Luminaires with Different Upward Light Output Ratios and the Use of Calculated Veiling Luminance to Determine Contrast Performance

Luminance Stepped Decreasing Ratio of the Tunnel Entrance Enhanced Lighting Based on Visual Performance.

Influence of luminance and luminance longitudinal uniformity of tunnel lighting on drivers' comprehensive visual performance

Road Lighting: A Pilot Study Investigating Improvement of Visual Performance Using Light Sources with a Larger Gamut Area

Assessing Glare. Part 1: Comparing Uniform and Non-Uniform Led Luminaires

The correlation of veiling luminance and unified glare rating with a transfer function

Glare Model For Non-Uniform White Led Luminaires

Comparison and Application of Mesopic Models under the Tunnel Environment

Study On Perception Of Veiling Reflection Of Desktop Luminaires With Different Ccts And Optical Designs

Exploring the Applicability of the Unified Glare Rating for an Outdoor Non-Uniform Residential Luminaire

Assessing Uniformity Of Illuminance Based On A Led Tunable System

Assessing glare. Part 2: Modifying Unified Glare Rating for uniform and non-uniform LED luminaires

A Study on Peripheral Visibility under Different Headlamp Low-beam Pattern

Comparison Research of Street Lamps: Characteristic Parameters and Lighting Performance of Light-Emitting Diodes, High Pressure Sodium Lamps and Ceramic Discharge Metal Halide Lamps

Discussion on Criteria of Light Source Selection for Road Lighting

Superior Application of LED to Street Lighting

A Study on Lighting Uniformity for LED Smart Lighting System

Status of Solid-State Lighting Based on Entries to the 2010 Us Doe Next Generation Luminaire Competition

A study on overhead glare in office lighting conditions

The Application of Performance Based Method in Road Lighting

Comparing The Quality Of The Led Based And Conventional Cie Illuminant Simulators