Abstract:In this study, the process of carbon dioxide (CO2) capture directly from ambient air in a conventional monoethanolamine (MEA) absorption process was simulated and optimized using a rate-based model in Aspen Plus. The process aimed to capture a specific amount (148.25 Nm3/h) of CO2 from the air, which was determined by a potential application aiming to produce synthetic methane from the output of a 2.7 MW electrolyser (593 Nm3/h H2). We investigated the technical performance of the process by conducting a sensitivity analysis around different parameters such as air humidity, capture rate defined as a ratio of moles of CO2 captured during the process to the total mole of CO2 in the feed stream, CO2 loading of lean and rich absorption liquids and reboiler temperature, and evaluated the energy consumption and overall cost in this system. In order to meet the design requirement for standard packed columns, the rich absorption liquid was circulated to the top of the absorber. A capture rate of 50% was selected in this process as a baseline. At higher capture rates, the required energy per ton of captured CO2 increases due to a higher steam stripping rate, required in the desorber, and at lower capture rates, the size of equipment, in particular, absorber and blowers increases due to the need for processing a significantly larger volume of air at the given CO2 production volume. At the base case scenario, a reboiler duty of 10.7 GJ/tCO2 and an electrical energy requirement of 1.4 MWh/tCO2 were obtained. The absorber diameter and height obtained were 10.4 and 4.4 m, respectively. The desorber is found to be relatively small at 0.54 m in diameter and 3.0 m in height. A wash water section installed at top of the absorber decreased the MEA loss to 0.28 kg/ton CO2. However, this increased capital cost by around 60% resulting in CO2 capture costs of $1,691 per ton CO2 for the MEA base scenario. Based on the techno-economic analysis, assuming a non-volatile absorbent rather than MEA thereby avoiding a wash water section, and using an absorption column built from cheaper materials, the estimated cost per ton of CO2 produced was reduced to $676/tCO2. The overall cost range was between $273 and $1,227 per ton of CO2 depending on different economic parameters such as electricity ($20–$200/MWh) and heat price ($2–$20/GJ), plant life (15–25 years) and capital expenditure (±30%). In order to reduce the cost further, the use of innovative cheap gas-liquid contactors that operate at lower liquid to gas ratios is crucial.

Energy consumption and economic analysis of CO 2 capture from flue gas by membrane separation coupled with hydrate method

Systematic Design and Optimization of a Membrane–Cryogenic Hybrid System for CO2 Capture

Optimal Design of a Subambient Membrane Separation System with Work and Heat Integration for CO2 Capture

Post-combustion CO2 capture and separation in flue gas based on hydrate technology:A review

High Selectivity CO 2 Capture from Biogas by Hydration Separation Based on the Kinetic Difference in the Presence of 1,1-Dichloro-1-fluoroethane

CO2 Capture Technology Based on Gas Hydrate Method: a Review

Economic Analysis of CO2 Separation from Coal-Fired Flue Gas by Chemical Absorption and Membrane Absorption Technologies in China

Promotion of Hydrate-Based CO2 Capture from Flue Gas by Additive Mixtures (THF (tetrahydrofuran) + TBAB (Tetra-N-butyl Ammonium Bromide))

Understanding the performance of membrane for direct air capture of CO2

CO2 Capture by Using a Membrane-absorption Hybrid Process in the Nature Gas Combined Cycle Power Plants

Techno-Economic Assessment for CO2 Capture From Air Using a Conventional Liquid-Based Absorption Process

Insight and Comparison of Energy-efficient Membrane Processes for CO2 Capture from Flue Gases in Power Plant and Energy-intensive Industry

Spacially Affordable Decarbonization of Coal-Fired Power Plants Via Membrane-Based On-Site CO2 Absorption: A Techno-Economic Analysis

Superior energy-saving splitter in monoethanolamine-based biphasic solvents for CO2 capture from coal-fired flue gas

Capture by Using a Membrane-Absorption Hybrid Process in 1 the Nature Gas Combined Cycle Power Plants

Study on developing a novel continuous separation device and carbon dioxide separation by process of hydrate combined with chemical absorption

Hydrate-based Carbon Capture via Pressure Swing in a Packed Bed of Ice

Integration of membrane contactors and catalytic solvent regeneration for efficient carbon dioxide capture

Highly efficient separation and equilibrium recovery of H2/CO2 in hydrate-based pre-combustion CO2 capture

Simulation and Optimization of Carbon Dioxide Capture Using Water-Lean Solvent from Industrial Flue Gas