High Selectivity CO 2 Capture from Biogas by Hydration Separation Based on the Kinetic Difference in the Presence of 1,1-Dichloro-1-fluoroethane

Yanhong Wang,Jinfeng Lu,Jing Qi,Xuemei Lang,Shuanshi Fan,Chi Yu,Gang Li
DOI: https://doi.org/10.1021/acs.energyfuels.1c01007
2021-06-23
Abstract:The separation of a gas mixture by hydrate technology is considered one of the most promising new separation technologies. Previous studies on biogas purified by hydrate separation had high energy consumption because of low separation efficiency. In this paper, we used 1,1-dichloro-1-fluoroethane (HCFC-141b) as an additive to capture CO<sub>2</sub> from a mixture gas of 67.00 mol % CH<sub>4</sub> and 33.00 mol % CO<sub>2</sub>, which not only reduced the hydrate formation pressure but also enhanced the difference of methane and carbon dioxide hydrate formation kinetics. The influence of HCFC-141b concentration, feed gas pressure, and initial gas/liquid volume ratio on separation efficiency and the kinetics of hydrate formation were investigated. The results showed that the CO<sub>2</sub> captured ratio was 97.03% at 284.1 K @2MP and the separation factor was 61.38. The largest CO<sub>2</sub> captured ratio was 97.89%. The concentration of CH<sub>4</sub> in the residual gas phase increased from 67.00 to 98.01 mol %. The maximum gas hourly space velocity of the reactor reached 14.45 h<sup>–1</sup>, and the hydrate formation rate constant was 2.15 × 10<sup>–4</sup> (mol<sup>2</sup>/(s·J)). Furthermore, the energy consumption was calculated by Aspen HYSYS software. The energy consumption of CH<sub>4</sub> obtained from biogas at 284.1 K @2MP is 0.3530 kWh/kg<sub>CH<sub>4</sub></sub>. HCFC-141b acts as a kinetic and thermal promoter, which improved the energy efficiency of hydrate separation and reduced the energy consumption.This article has not yet been cited by other publications.
energy & fuels,engineering, chemical
What problem does this paper attempt to address?