Abstract:Herein, a new phase change absorbent N‐aminoethylpiperazine/diethylene glycol dimethyl ether/H2O is developed to absorb carbon dioxide in flue gas. Through a series of experimental operations, the optimal absorption and desorption conditions are found, and the mechanism and renewable energy consumption are studied to determine whether it is suitable for industrial applications. Excessive carbon dioxide (CO2) emissions can lead to environmental problems, and the use of phase change absorbents for CO2 capture has received much attention due to their excellent absorption and desorption properties. Herein, a novel liquid–liquid phase change absorbent consisting of N‐aminoethylpiperazine (AEP), diethylene glycol dimethyl ether (DEGDME), and H2O is utilized. Under the optimal absorption conditions, the absorption capacity is 1.23 mol CO2·mol−1 amine. The rich‐phase viscosity of the AEP/DEGDME/H2O solution is only 6.2 mPa s−1, and the rich phase‐to‐volume ratio is 52.7%, which is suitable for industrial applications. After five cycles of absorption–desorption experiments, the cyclic capacity reaches 0.62 mol CO2·mol−1 amine. However, it should be noted that this leads to an increase in the viscosity of the solution with time. The 13C Nuclear Magnetic Resonance characterization is used to analyze the material distribution and phase separation mechanism, and it is found that during the absorption process, the carbamate and carbonate products generated by the reaction of the amino group in the AEP with CO2 are mainly located in the rich phase, while the DEGDME and H2O mainly remain in the lean phase. In the desorption process, most of the absorbed products are decomposed, and the regeneration efficiency is 66.8%. Through the regeneration energy consumption experiment, when the regeneration efficiency is 56%–67%, the total regeneration energy consumption is 2.71–2.89 GJ t−1 CO2, which is 0.91–1.09 GJ t−1 CO2 lower than that of the regeneration efficiency of 30 wt% MEA solution at 63%, which indicates that this absorbent has certain energy‐saving advantages.

Phase Change Study of a New Two-Phase Absorbent Based on DAP

Novel Diamine Dmapa-Sulfolane-Water Biphasic Absorbent for Equimolar Co2 Absorption: Performance and Mechanisms

Kinetic Analysis of an Anion Exchange Absorbent for Co2 Capture from Ambient Air

Phase Separation Behavior and CO2 Absorption Kinetic Analysis of DETA/DEA/DMAC Biphasic Absorbent

Regulating the absorption and solid regeneration performance of a novel anhydrous solid–liquid phase change absorbent for carbon capture

Phase Separation Behavior and CO2 2 Absorption Kinetic Analysis of DETA/ DEA/DMAC Biphasic Absorbent

A Novel Phase Change Absorbent for CO2 Capture with Low Viscosity and Effective Absorption–Desorption Properties

CO 2 absorption by diethylenetriamine-based phase change absorbents: Phase change mechanism and absorption performance

Research of Novel Polyamine-Based Biphasic Absorbents for CO2 Capture Using Alkanolamine to Regulate the Viscosity and Mechanism Analysis

Regulation mechanism of CO 2 capture into the novel non-aqueous biphasic solvent: Solid-liquid phase change controllable

Research of novel polyamine-based biphasic absorbents for CO 2 capture using alkanolamine to regulate the viscosity and mechanism analysis

Enhancing Capture Performance of Physical Solvent Biphasic Absorbent Using Tepa As Activator for Efficient Co2 Capture from Flue Gas

A low energy-consuming phase change absorbent of MAE/DGM/H2O for CO2 capture

Liquid–Solid Phase‐Change Behavior of Diethylenetriamine in Nonaqueous Systems for Carbon Dioxide Absorption

Experimental study on CO2 capture using 2‐(2‐aminoethylamino)ethanol/N,N‐diethyl‐ethanolamine/sulfolane phase‐change absorbents

Mass Transfer and Reaction Mechanism of CO2 Capture into a Novel Amino Acid Ionic Liquid Phase-Change Absorbent

Combined experimental and computational study on the effect of solvent structure on developing CO 2 biphasic absorbents

Mass transfer and reaction mechanism of CO 2 capture into a novel amino acid ionic liquid phase-change absorbent

Design and performance evaluation of low-volatility and low-viscosity absorbents for CO2 capture

Study of New Blended Chemical Absorbents to Absorb CO2

Analysis of the changes in the absorption and regeneration performance of diethylenetriamine in carbon capture environments with functionalized alcohols and mixed amines