Abstract:Proceedings of the Institution of Mechanical Engineers, Part E: Journal of Process Mechanical Engineering, Ahead of Print. The conventional contour method (CM) needs multiple cuts at different locations to obtain the multiple components of residual stress in a specimen. To improve the convectional CM, an extended CM was proposed in the present study to determine the multiple stress components in a thick butt-welded joint without cutting at different locations. First, the longitudinal residual stress in the specimen was measured with the CM, then a thin slice was cut from the after-cut specimen, and the remaining transverse stress in the slice was measured with the X-ray diffraction method and the released transverse stress of the slice was constructed by the finite element analysis (FEA), and finally, the transverse stress on the same cross-section was obtained by the superposition of the remaining and the released transverse stresses on the slice. A two-cut CM was also carried out to get the transverse stress along the weld line center. The stress distribution characteristics of the specimen and the release extent of the transverse stress in the slice were discussed. The results show that the extended CM can evaluate the original biaxial residual stresses on a cross-section without multiple cuts at different locations. The transverse stress distribution trend obtained by the extended CM is close to that from the two-cut CM. Without considering the compressive stress induced by ultrasonic impact treatment, the longitudinal stress in the weld region is tensile with a maximum value of 550 MPa and the transverse stress at the weld line center is self-equilibrating with a maximum value reaching 552 MPa. Two peaks of tensile longitudinal and transverse stress appear at a certain distance beneath the top and bottom surfaces. When cutting a thin slice with a thickness of 5 mm along the transverse direction from the after-cut specimen, over 82% of the original tensile transverse stresses are retained in the slice.

Behaviour of stresses in circumferential butt welds of steel pipe under superimposed axial tension loading

Nonlinear Transient Analysis of Butt Welding Based on Finite Element Method

Three-dimensional finite element simulation of residual stresses in circumferential welds of steel pipe including pipe diameter effects

Three-dimensional finite element analysis of residual stresses in dissimilar steel pipe welds

Prediction of Residual Stress Distributions in Welded Sections of P92 Pipes with Small Diameter and Thick Wall Based on 3D Finite Element Simulation

Thermal, metallurgical and mechanical analysis of circumferentially multi-pass welded P92 steel pipes

Plastic Limit Load Analysis for Pressure Pipe with Incomplete Welding Defects Based on the Extended Net Section Collapse Criteria

Residual stress simulation in thin and thick-walled stainless steel pipe welds including pipe diameter effects

Plastic Limit Load Analysis of Pressure Pipes Containing Incomplete Welding Defects under Combined Loadings

Three-dimensional finite element analysis on welding residual stresses of construction steel

Evaluation of multiple residual stress components in a thick welded joint using extended contour method

Research On Safety Assessment Method For Pressure Pipe With Incomplete Welding Defects Under Complicated Loadings

Numerical simulation of bending deformation induced by multi-seam welding of a steel-pipe structure

Research Of Weld On Axial Buckling Stress Of Multilayer Combined Cylindrical Shells

Effect of Post-Weld Heat Treatment on the Plastic Buckling of Welded Cylindrical Shells

Analysis of Crack Propagation of Annular Butt Weld and Distribution of Weld-Induced Residual Stress

Stress Analysis of the Effect of Additional Load on the Butt Weld of Suspended Pipeline With Variable Wall Thickness

Effects of Welding and Constraint Conditions on the Welding Residual Stress and Hardness of Type 316 Stainless Steel Pipe

Distribution and Characteristics of Residual Stresses in Super Duplex Stainless Steel Pipe Weld

Comparative study on girth weld-induced residual stresses between austenitic and duplex stainless steel pipe welds

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline