Abstract:Coal liquefaction residue (CLR) has a high content of carbon and organic substances. However, sulfur and inorganics pose a challenge for the high-value-added utilization of CLR. In this work, general-purpose carbon fiber was successfully prepared by the new method of chlorination–dechlorination using CLR as raw material and benzyl chloride as chlorinating agent. The effect of benzyl chloride addition amount on the property of isotropic pitch precursor and the performance of general-purpose carbon fiber were investigated. The results showed that the as-prepared pitch precursors were dominated by carbon elements and contained small numbers of hydrogen, oxygen, nitrogen, and sulfur. The characteristic peaks generated from chlorine elements were observed in both FTIR and XPS spectra. The peaks at the wavenumbers of 1490 cm −1 and 696 cm −1 corresponded to the vibration of C–Cl bond, and a tiny Cl 2p peak located at 200.0 eV was observed by reducing the noise of XPS spectra. It indicates that the trace chlorine remains in the as-synthesized isotropic pitch precursor even after undergoing dechlorination. The molecular compositions of isotropic pitches were mainly polyaromatic hydrocarbons, and the chlorination–dechlorination promotes the oligomerization of polyaromatic hydrocarbons to form dimers and trimers. Therefore, the polycondensed degree and carbon aromaticity were improved. It is known from 13 C NMR analysis that the effect of chlorine–dechlorination makes the molecular structure of pitches transform more linear, thus enhancing their spinnability. In addition, the higher the amount of benzyl chloride added, the better the property of isotropic pitch was. The pitch of BC-30 and BC-40 showed excellent spinnability, stabilized property, and carbonized property compared to other pitches. The morphology of obtained carbon fiber was homogeneous and smooth without defects in surface and section. The as-prepared general-purpose carbon fiber demonstrated good tensile strength up to 1220 MPa with an average diameter of 8.5 μm.

Mechanism and application of halogenation–dehalogenation in the development of pitch-based carbon fiber: A review

Controllable synthesis of a carbonaceous pitch from molecular dimension by a novel method of chlorination-dechlorination

Controllable synthesis of isotropic pitch precursor for general purpose carbon fiber using waste ethylene tar via bromination–dehydrobromination

Effects of Bromination-Dehydrobromination on the Microstructure of Isotropic Pitch Precursors for Carbon Fibers

Chlorination–dechlorination of coal liquefaction residue using benzyl chloride for general-purpose carbon fiber synthesis

Preparation of Heteroatom‐Doped Carbon Materials and Applications in Selective Hydrogenation

Modification of isotropic pitch by tailoring chemical structure and fraction contents for enhancing carbon fiber mechanical properties

Preparation of pitch precursor with excellent spinnability for general-purpose carbon fibre using coal tar pitch as raw material

Mesoscopic structure and properties of liquid crystalline mesophase pitch and its transformation into carbon fiber

Controllable Preparation of Spinnable Isotropic Pitches for Carbon Fibers with High Tensile Strength from Low-Cost Ethylene Tar Pitch by a Selective Photobromination–debromination Method

Pitch-based carbon materials: a review of their structural design, preparation and applications in energy storage

Mesophase pitch raw material used for preparing high-modulus high-thermal-conductivity carbon fiber, and preparation method thereof

Evaluating of the oxidative behaviors of isotropic pitch fractions for optimal the mechanical properties of isotropic pitch-based carbon fibers

Constructing the Bridge from Isotropic to Anisotropic Pitches for Preparing Pitch-Based Carbon Fibers with Tunable Structures and Properties

Microstructural investigation and performance of carbon matrix composites developed through facile pitch modification route

Influence of Oxygen Uptake on Pitch Carbon Fiber

Synthesis and Structural Evolution of Coal-Based Mesophase Pitch by Hydrogenation-Vacuum Thermal Polycondensation Process

Tuning the carbon morphology by pyrolysis in AlCl3–NaCl molten salt from coal tar pitch

The effect of hydrogenation degree on the properties of coal-based spinnable mesophase pitch

Investigation on promotion effect of oxidative stabilization for pitch‐based fiber by co‐carbonization of coal tar pitch and atmospheric residual

Improving carbon/carbon composites mechanical and thermal properties by the co‐carbonization of pre‐oxidized carbon fiber and pitch