Abstract:Concrete structures are widely used in construction because of their many advantages, including high corrosion resistance, durability, low operating costs, and the ability to design any geometry. However, they also have some disadvantages, such as their high dead weight and susceptibility to cracking. Although this material is widely used globally, new types of concrete, such as high-strength or lightweight aggregate-based, are still being developed. This requires constant control and testing in both laboratory and field conditions. Concrete is a heterogeneous material due to the influence of aggregate grains and local discontinuities, voids or pores. Given these characteristics, it is clear that most conventional diagnostic solutions, such as spot foil strain gauges or extensometers, are unable to accurately analyse these localised effects as they average local strains over the measurement base. In contrast, distributed fibre optic sensing (DFOS) enables strain readings to be taken with millimetre geometric resolution, significantly extending the structural assessment capability. The article describes research on standard concrete cylinders equipped with surface-mounted optical fibres for simultaneous measurements of distributed strains in both the longitudinal direction (compression zone) and circumference direction (tension zone). The novelty of the proposed approach, apart from the way of arranging the sensing fibres on the specimens, lies mainly in the new diagnostic approach that allow (1) the evaluation of the homogeneity of the concrete using statistical parameters, (2) the identification of microcracking and (3) the identification of near-to-failure state based on Poisson's ratio analysis. Twenty cylindrical specimens were laboratory tested using reference techniques to validate the performance of the DFOS-based system and to provide data for statistical evaluation. The results indicate the possibility of detecting the approaching damage even without knowledge of the material properties of the specimen or the initial stress level at the moment of starting the measurements. The discussion also covered future research directions and potential improvements.

Advanced measurement techniques for plastic shrinkage and cracking in 3D-printed concrete utilising distributed optical fiber sensor

Investigation of the Internal Structure of Hardened 3D-Printed Concrete by X-CT Scanning and Its Influence on the Mechanical Performance.

Crack monitoring on concrete structures with distributed fiber optic sensors—Toward automated data evaluation and assessment

Methods for measuring plastic shrinkage and related cracking of 3D-printed concrete

Bond shear performances and constitutive model of interfaces between vertical and horizontal filaments of 3D printed concrete

Towards an Automated Crack Monitoring using Distributed Fiber Optic Sensors

Plastic shrinkage cracking in 3D printed concrete

Quantification of plastic shrinkage and plastic shrinkage cracking of the 3D printable concretes using 2D digital image correlation

Embedded Distributed Optical Fiber Sensors in Reinforced Concrete Structures—A Case Study

Experimental Research on Monitoring Concrete Expansion and Cracking Induced by Corrosion based on Distributed Optical Fiber Sensor

Methodology for Quantifying Features of Early-Age Concrete Cracking from Laser Scanned 3D Data

Pore structure, internal relative humidity, and fiber orientation of 3D printed concrete with polypropylene fiber and their relation with shrinkage

Application of Distributed Optical Fiber Sensing Technology to the Detection and Monitoring of Internal Swelling Pathologies in Massive Concrete Blocks

Distributed fiber optic sensing for internal strain monitoring in full life cycle of concrete slabs with BOFDA technology

Structural concrete measurements: New distributed approach for standard specimens

Shrinkage and mechanical properties optimization of spray-based 3D printed concrete by PVA fiber

A Novel Method of Embedding Distributed Optical Fiber Sensors for Structural Health Monitoring

Experimental Research on Corrosion-Induced Cracking Monitoring Based on Optical Fiber Sensor

Shrinkage and Cracking Properties of Cellulose Fiber–Concrete Composites for 3D Printing by Leveraging Internal Curing

A mechanical characteristic capture method considering printing configurations for buildability modeling in concrete 3D printing

Distributed Fiber-Optic Strain Sensing of an Innovative Reinforced Concrete Beam–Column Connection